Search results
Results from the WOW.Com Content Network
A hold down resisting uplift from a timber shear wall. Holdown (holdown, hold-down, or hold down) or tie-down in structural engineering refers to the steel device or hardware that is installed at the end of a plywood shear wall. The hold downs provide uplift resistance against the overturning moment imposed on the wall due to "in-plane" lateral ...
If the toilet is flushed from a tank, a large holding cistern is mounted above the toilet, containing approximately 4.5 to 6 L (1.2 to 1.6 US gallons) of water in modern designs. This tank is built with a large drain 50 to 75 mm (2 to 3 inches) diameter hole at its bottom covered by a flapper valve that allows the water to rapidly leave the ...
The Hanford Tank Waste Treatment and Immobilization Plant, known as the Vit Plant, will process the nuclear waste at the Hanford Site in Washington into a solid glass form using vitrification.
When multiple tanks share a bund, the capacity is based on the largest tank. One of the most common designs for large tanks is a concrete or masonry wall around the tank with a concrete floor. [3] Concrete works very well for many liquids, but it is unsuitable for some applications like containing strong acids. Using earth berms for bunding is ...
Many thousands of old underground tanks were replaced with newer tanks made of corrosion resistant materials (such as fiberglass, steel clad with a thick FRP shell, and well-coated steel with galvanic anodes) and others constructed as double walled tanks to form an interstice between two tank walls (a tank within a tank) which allowed for the ...
If suitably square and flush, the stop that spans the full width of the bench hook (the hook) can also be used as a fence so the bench hook can be used as a short shooting board, for trueing the ends of pieces using a hand plane. [4] [2] A pair of bench hooks made to the same dimensions can be used in unison for supporting longer pieces of wood.
Since the surface area of the tank is WL, and v s = Q/WL, v h = Q/WH, where Q is the flow rate and W, L, H is the width, length, depth of the tank. According to Eq. 1, this also is a basic factor that can control the sedimentation tank performance which called overflow rate. [13]
The still well serves to isolate the device from any ripples that might be present in the sample being measured, while allowing the water level to equalize. The measurement is taken by turning the knob to lower the hook through the surface of the water until capillary action causes a small depression to form around the tip of the hook. The knob ...