Search results
Results from the WOW.Com Content Network
Figure 2: Weight (W), the frictional force (F r), and the normal force (F n) acting on a block.Weight is the product of mass (m) and the acceleration of gravity (g).In the case of an object resting upon a flat table (unlike on an incline as in Figures 1 and 2), the normal force on the object is equal but in opposite direction to the gravitational force applied on the object (or the weight of ...
The normal force is taken perpendicularly to the direction of relative motion; under the influence of gravity, and in the common case of an object supported by a horizontal surface, the normal force is just the weight of the object itself. As there is no relative motion under static friction, no work is done, and hence no energy can be dissipated.
Force is the action of one body on another. A force is either a push or a pull, and it tends to move a body in the direction of its action. The action of a force is characterized by its magnitude, by the direction of its action, and by its point of application (or point of contact). Thus, force is a vector quantity, because its effect depends ...
A small holding force exerted on one side can carry a much larger loading force on the other side; this is the principle by which a capstan-type device operates. A holding capstan is a ratchet device that can turn only in one direction; once a load is pulled into place in that direction, it can be held with a much smaller force.
The normal force N is equal, opposite, and collinear to the gravitational force mg so the net force and moment is zero. Consequently, the object is in a state of static mechanical equilibrium. In classical mechanics, a particle is in mechanical equilibrium if the net force on that particle is zero.
The static friction force must be overcome by an applied force before an object can move. The maximum possible friction force between two surfaces before sliding begins is the product of the coefficient of static friction and the normal force: =.
A solid is a material that can support a substantial amount of shearing force over a given time scale during a natural or industrial process or action. This is what distinguishes solids from fluids, because fluids also support normal forces which are those forces that are directed perpendicular to the material plane across from which they act and normal stress is the normal force per unit area ...
magnetohydrodynamics (ratio of the Lorentz force to the viscosity in magnetic convection) Colburn J factors: J M, J H, J D: turbulence; heat, mass, and momentum transfer (dimensionless transfer coefficients) Darcy friction factor: C f or f D: fluid mechanics (fraction of pressure losses due to friction in a pipe; four times the Fanning friction ...