Search results
Results from the WOW.Com Content Network
Design for manufacturability (also sometimes known as design for manufacturing or DFM) is the general engineering practice of designing products in such a way that they are easy to manufacture. The concept exists in almost all engineering disciplines, but the implementation differs widely depending on the manufacturing technology.
The engineering design process, also known as the engineering method, is a common series of steps that engineers use in creating functional products and processes. The process is highly iterative – parts of the process often need to be repeated many times before another can be entered – though the part(s) that get iterated and the number of such cycles in any given project may vary.
The traditional DMAIC Six Sigma process, as it is usually practiced, which is focused on evolutionary and continuous improvement manufacturing or service process development, usually occurs after initial system or product design and development have been largely completed. DMAIC Six Sigma as practiced is usually consumed with solving existing ...
Design for additive manufacturing (DfAM or DFAM) is design for manufacturability as applied to additive manufacturing (AM). It is a general type of design methods or tools whereby functional performance and/or other key product life-cycle considerations such as manufacturability, reliability, and cost can be optimized subjected to the capabilities of additive manufacturing technologies.
DFMA (also sometimes rendered as DfMA) is an acronym for design for manufacture and assembly.DFMA is the combination of two methodologies; design for manufacture, which means the design for ease of manufacture of the parts that will form a product, and design for assembly, which means the design of the product for ease of assembly deriving creative ideas at the same time.
Advanced Supersonic Transport (AST) model in wind tunnel. The aircraft design process is a loosely defined method used to balance many competing and demanding requirements to produce an aircraft that is strong, lightweight, economical and can carry an adequate payload while being sufficiently reliable to safely fly for the design life of the aircraft.
The design for lean manufacturing equation is design for lean manufacturing success = strategic values minus the drivers of design and process wastes. A good design is one that simultaneously reduces waste and delivers value. [17] [18] There are multiple drivers that cause product, process, and lifecycle wastes. [19]
Illustration of FEOL (device generation in the silicon, bottom) and BEOL (depositing metalization layers, middle part) to connect the devices. CMOS fabrication process. The front end of line (FEOL) is the first portion of IC fabrication where the individual components (transistors, capacitors, resistors, etc.) are patterned in a semiconductor substrate. [1]