Search results
Results from the WOW.Com Content Network
Range ambiguity resolution is a technique used with medium pulse-repetition frequency (PRF) radar to obtain range information for distances that exceed the distance between transmit pulses. This signal processing technique is required with pulse-Doppler radar .
In pulsed radar and sonar signal processing, an ambiguity function is a two-dimensional function of propagation delay and Doppler frequency, (,).It represents the distortion of a returned pulse due to the receiver matched filter [1] (commonly, but not exclusively, used in pulse compression radar) of the return from a moving target.
Radial velocity aliasing occurs when reflections arrive from reflectors moving fast enough for the Doppler frequency to exceed the pulse repetition frequency (PRF). Frequency ambiguity resolution is required to obtain the true radial velocity when the measurements is made using a system where the following inequality is true.
Pulse-Doppler signal processing is a radar and CEUS performance enhancement strategy that allows small high-speed objects to be detected in close proximity to large slow moving objects. Detection improvements on the order of 1,000,000:1 are common.
This is what requires STAP to be an adaptive technique. Note that even in this idealized example, in general, we must steer over the 2-D angle-Doppler plane at discrete points to detect potential targets (moving the location of the 2-D sinc main lobe shown in the figure), and do so for each of the range bins in our system.
All of the typical measurements that a non-monopulse system make are done using the sum channel, e.g., range, Doppler, and angle. However, the angle measurement is limited in that the target could be anywhere within the beam width of the sum beam, and therefore the system can only assume that the beam pointing direction is the same as the ...
In the cross-range coordinate, the similar resolution is mainly proportional to the bandwidth of the Doppler shift of the signal returns within the beamwidth. Since Doppler frequency depends on the angle of the scattering point's direction from the broadside direction, the Doppler bandwidth available within the beamwidth is the same at all ranges.
If the radar was locked on to the aircraft, it will hopefully remain locked to this second pulse as the aircraft moves away from the original location. Eventually, the aircraft will fall outside the range gate and disappear, while the radar continues tracking the false signal. Thus, the false signal is said to "pull the range gate off the target".