Search results
Results from the WOW.Com Content Network
4-inch (100 mm) hollow CMU (concrete masonry unit) [34] 45 Double layer of 1 ⁄ 2-inch (13 mm) drywall on each side, wood studs, batt insulation in wall 46 Single layer of 1 ⁄ 2-inch (13 mm) drywall, glued to 6-inch (150 mm) lightweight concrete block wall, painted both sides 46 6-inch (150 mm) hollow CMU (concrete masonry unit) [34] 48
Sandcrete is usually used as hollow rectangular blocks similar to concrete masonry units, often 45 centimetres (18 in) wide, 15 centimetres (5.9 in) thick, and 30 centimetres (12 in) with hollows that run from top to bottom and occupy around one third of the volume of the block.
A concrete slab is a common structural element of modern buildings, consisting of a flat, horizontal surface made of cast concrete. Steel- reinforced slabs, typically between 100 and 500 mm thick, are most often used to construct floors and ceilings, while thinner mud slabs may be used for exterior paving ( see below ).
The compressive strength of concrete blocks and masonry walls varies from approximately 3.4 to 34.5 MPa (500–5,000 psi) based on the type of concrete used to manufacture the unit, stacking orientation, the type of mortar used to build the wall, and whether it is a load-bearing partition or not, among other factors. [18] [19] [20] [21]
Because of the relatively low temperature used, AAC blocks are not considered to be a fired brick but a lightweight concrete masonry unit. After the autoclaving process, the material is stored and shipped to construction sites for use. Depending on its density, up to 80% of the volume of an AAC block is air. AAC's low density also accounts for ...
A board foot is a United States and Canadian unit of approximate volume, used for lumber. It is equivalent to 1 inch × 1 foot × 1 foot (144 cu in or 2,360 cm 3). It is also found in the unit of density pounds per board foot. In Australia and New Zealand the terms super foot or superficial foot were formerly used for this unit. The exact ...
A single wythe of brick that is not structural in nature is referred to as a masonry veneer. A multiple-wythe masonry wall may be composed of a single type of masonry unit layered to increase its thickness and structural strength, or different masonry units chosen by function, such as an economical concrete block serving a structural purpose ...
Logo of Eurocode 2 An example of a concrete structure. In the Eurocode series of European standards (EN) related to construction, Eurocode 2: Design of concrete structures (abbreviated EN 1992 or, informally, EC 2) specifies technical rules for the design of concrete, reinforced concrete and prestressed concrete structures, using the limit state design philosophy.