Search results
Results from the WOW.Com Content Network
Eternit is a registered trademark for a brand of fibre cement currently owned by the Belgian company Etex. [1] Fibre is often applied in building and construction materials , mainly in roofing and facade products.
In the United States, the International Building Code and ASTM International define Exterior Insulation and Finish System (EIFS) as a non-load-bearing exterior wall cladding system that consists of an insulation board attached either adhesively, mechanically, or both, to the substrate; an integrally reinforced base coat; and a textured protective finish coat.
Metal profile sheet systems are used to build cost efficient and reliable envelopes of mostly commercial buildings. They have evolved from the single skin metal cladding often associated with agricultural buildings to multi-layer systems for industrial and leisure application. As with most construction components, the ability of the cladding to ...
Reglet detail. A reglet is found on the exterior of a building along a masonry wall, chimney or parapet that meets the roof. It is a groove cut within a mortar joint that receives counter-flashing meant to cover surface flashing used to deflect water infiltration. Reglet can also refer to the counter-flashing itself when it is applied on the ...
In the modern era, tie-rods are made of iron or steel, and serve to reinforce vaults, arches, and in general masonry structures. Reinforced masonry walls are strengthened through a tie-rod that connects between parallel walls at the floor-level, which creates a horizontal compression state, thereby increasing the wall's shear strength. [ 6 ]
Nigerite Limited is a firm that manufactures roofing and ceiling sheets and provides building components to the construction and building industry in Nigeria. It was established in April 1959 as a joint venture between the Western Regional government, Eternit Group [1] who had majority shareholding, Patterson Zochonis and John Holt.
Members of the union finish interior walls and ceilings of buildings and apply plaster on masonry, metal, and wire lath or gypsum. Cement masons are responsible for all concrete construction, including pouring and finishing of slabs, steps, wall tops, curbs and gutters, sidewalks, and paving.
EN 1996-1-2 deals with the design of masonry structures for the accidental situation of fire exposure, and is intended to be used in conjunction with EN 1996-1-1, EN 1996-2, 1996-3 and EN 1991-1-2. This part only identifies differences from, or supplements to, normal temperature design and it deals only with passive methods of fire protection.