Ad
related to: what is a feeder tap- Motors
New and Used Vehicles and Parts.
Find Items from Every Automaker.
- Sell on eBay
168 Million Shoppers Want to Buy.
Start Making Money Today.
- Toys
Come Out and Play.
Make Playtime a Celebration!
- Electronics
From Game Consoles to Smartphones.
Shop Cutting-Edge Electronics Today
- Motors
Search results
Results from the WOW.Com Content Network
Similar techniques can surreptitiously tap fiber for surveillance, although this is rarely done where electronic equipment used in telecommunication is required to allow access to any phone line for tapping by legal authorization. Tapping the fiber means that all signals from every communications source being routed through the fiber are ...
A feeder line is a peripheral route or branch in a network, which connects smaller or more remote nodes with a route or branch carrying heavier traffic. The term is applicable to any system based on a hierarchical network. In telecommunications, a feeder line branches from a main line or trunk line.
The 240 V secondary winding is center-tapped, and the center neutral wire is grounded, making the two end conductors "hot" concerning the center tap. These three wires run down the service drop to the building's electric meter and service panel. Connecting a load between the hot wire and the neutral gives 120 volts, which is used for lighting ...
Secondary feeders are connected between primary feeders and distributors. Distributors are water mains that are located near the water users, which also supply water to individual fire hydrants. [8] A service line is a small diameter pipe used to connect from a water main through a small tap to a water meter at user's location.
On the three secondary terminals, the center tap is grounded with a short strap to the transformer case. A split-phase or single-phase three-wire system is a type of single-phase electric power distribution. It is the alternating current (AC) equivalent of the original Edison Machine Works three-wire direct-current system. Its primary advantage ...
In electrical distribution, a fuse cutout or cut-out fuse (often referred to as a cutout) is a combination of a fuse and a switch, used in primary overhead feeder lines and taps to protect distribution transformers from current surges and overloads. An overcurrent caused by a fault in the transformer or customer circuit will cause the fuse to ...
An autotransformer has a single winding with two end terminals and one or more terminals at intermediate tap points. It is a transformer in which the primary and secondary coils have part of their turns in common. The portion of the winding shared by both the primary and secondary is the common section.
Wiretapping, also known as wire tapping or telephone tapping, is the monitoring of telephone and Internet-based conversations by a third party, often by covert means.The wire tap received its name because, historically, the monitoring connection was an actual electrical tap on an analog telephone or telegraph line.
Ad
related to: what is a feeder tap