Search results
Results from the WOW.Com Content Network
Read-only memory (ROM) is a type of non-volatile memory used in computers and other electronic devices. Data stored in ROM cannot be electronically modified after the manufacture of the memory device. Read-only memory is useful for storing software that is rarely changed during the life of the system, also known as firmware.
A portion of the computer's hard drive is set aside for a paging file or a scratch partition, and the combination of physical RAM and the paging file form the system's total memory. (For example, if a computer has 2 GB (1024 3 B) of RAM and a 1 GB page file, the operating system has 3 GB total memory available to it.)
Read–write memory, or RWM, is a type of computer memory that can be easily written to as well as read from using electrical signaling normally associated with running a software, and without any other physical processes.
The CAS signal is only needed to enable the output (the data out pins were held at high-Z while CAS was deasserted), so time from CAS assertion to data valid (t CAC) is greatly reduced. [63] Fast page mode DRAM was introduced in 1986 and was used with the Intel 80486.
In optical storage, three types of storage are usually recognized, and given customary abbreviations: read-only ("ROM"), Write once ("R") and read/writable ("RW", or for Blu-ray, "E" for "erasable"). Examples: CD-ROM represents the CD format, in its pre-recorded "read only" use; DVD+R represents a DVD "+" disc which can be written once only
The time to read the first bit of memory from a DRAM without an active row is T RCD + CL. Row Precharge Time T RP: The minimum number of clock cycles required between issuing the precharge command and opening the next row. The time to read the first bit of memory from a DRAM with the wrong row open is T RP + T RCD + CL. Row Active Time T RAS
The operating system will place actively used data in RAM, which is much faster than hard disks. When the amount of RAM is not sufficient to run all the current programs, it can result in a situation where the computer spends more time moving data from RAM to disk and back than it does accomplishing tasks; this is known as thrashing.
EEPROM or E 2 PROM (electrically erasable programmable read-only memory) is a type of non-volatile memory. It is used in computers, usually integrated in microcontrollers such as smart cards and remote keyless systems , or as a separate chip device, to store relatively small amounts of data by allowing individual bytes to be erased and ...