Search results
Results from the WOW.Com Content Network
The wheel trains of clocks are a little more varied, with different numbers of wheels depending on the type of clock and how many hours the clock runs between windings (the "going"). [2] However, the wheel trains of clocks and watches share the same terminology, and are similar enough that they can be described together.
The backward motion of the escape wheel during part of the cycle, called recoil, is one of the disadvantages of the anchor escapement.It results in a temporary reversal of the entire wheel train back to the driving weight with each tick of the clock, causing extra wear in the wheel train, excessive wear to the gear teeth, and inaccuracy.
Dondi constructed the clock, with its 107 gear wheels and pinions, entirely by hand. No screws were used, and every part was held together by over 300 tapering pins and wedges, with some parts being soldered. Most of the wheels have triangular shaped teeth, although some are blunt-nosed.
Large gears known as wheels mesh with small gears known as pinions. The wheels in a typical going train are the centre wheel, third wheel, and fourth wheel. A separate set of wheels, the motion work, divides the motion of the minute hand by 12 to move the hour hand and in watches another set, the keyless work, allows the hands to be set. Escapement
The lever is mounted on a shaft and is free to rotate between two fixed banking pins. At rest one of the escape wheel teeth will be locked against a pallet. As shown in the diagram, the escape wheel rotates clockwise and the entrance tooth is locked in place against the entrance pallet, the lever held in place by the left banking pin.
2. The gear trains used in clocks and watches have multiple stages of wheels and pinions in which the pinions have few leaves. Involute designs for these leaves would be undercut, making them too fragile and difficult to manufacture. 3. A large aspect of the design of watch and clock movements is the minimisation of friction.
A balance wheel, or balance, is the timekeeping device used in mechanical watches and small clocks, analogous to the pendulum in a pendulum clock. It is a weighted wheel that rotates back and forth, being returned toward its center position by a spiral torsion spring , known as the balance spring or hairspring .
The pins and part of escape wheel are visible at bottom center. The GIF is slowed down to make the mechanism movement easier to see. A Roskopf , pin-lever , or pin-pallet escapement is an inexpensive, less accurate version of the lever escapement , used in mechanical alarm clocks , kitchen timers , mantel clocks and, until the 1970s, cheap ...