enow.com Web Search

  1. Ads

    related to: rj45 cat-6 ethernet patch cable wiring

Search results

  1. Results from the WOW.Com Content Network
  2. Category 6 cable - Wikipedia

    en.wikipedia.org/wiki/Category_6_cable

    A Cat 6 patch cable, terminated with 8P8C modular connectors. Category 6 cable (Cat 6) is a standardized twisted pair cable for Ethernet and other network physical layers that is backward compatible with the Category 5/5e and Category 3 cable standards. Cat 6 must meet more stringent specifications for crosstalk and system noise than Cat 5 and ...

  3. Patch cable - Wikipedia

    en.wikipedia.org/wiki/Patch_cable

    A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.

  4. ANSI/TIA-568 - Wikipedia

    en.wikipedia.org/wiki/ANSI/TIA-568

    A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...

  5. Registered jack - Wikipedia

    en.wikipedia.org/wiki/Registered_jack

    A cable with a 50-pin connector on one end can support six fully wired 8P8C connectors or Ethernet ports on a patch panel with one spare pair. Alternatively, only the necessary pairs for 10/100 Ethernet can be wired allowing twelve Ethernet ports with a single spare pair. This connector is also used with spring bail locks for SCSI-1 connections.

  6. Ethernet crossover cable - Wikipedia

    en.wikipedia.org/wiki/Ethernet_crossover_cable

    For this, fiber patch cables with duplex connectors are normally configured as crossover as is the on-premises wiring. [ citation needed ] Thus, a simple connection with two patch cables at each end and a section of fixed cable in the middle has three crossovers in total, resulting in a working connection.

  7. Structured cabling - Wikipedia

    en.wikipedia.org/wiki/Structured_cabling

    Regardless of copper cable type (Cat 5e/6/6A), the maximum distance is 90 m for the permanent link installation, plus an allowance for a combined 10 m of patch cords at the ends. Cat 5e and Cat 6 can both effectively run power over Ethernet (PoE) applications up to 90 m. However, due to greater power dissipation in Cat 5e cable, performance and ...

  1. Ads

    related to: rj45 cat-6 ethernet patch cable wiring