Search results
Results from the WOW.Com Content Network
Mullard Circuits for Audio Amplifiers is a famous book by the Technical Services Department of Mullard Ltd, a British valve manufacturing company. First published in 1959 and then reprinted several times it contained a number of designs by Mullard engineers for high quality audio amplifiers, which were to be used by amateur constructors as well as by manufacturers as the basis for many ...
The company was known for the most powerful audio amplifiers of the era led by the Phase Linear D-500 introduced in 1978. It was a stereo power amplifier delivering 505 watts of clean (typically < 0.1% total harmonic distortion over 20 Hz–20 kHz) RMS power per channel. It had a retail price of $1395. Buyout
A phase-shift oscillator is a linear electronic oscillator circuit that produces a sine wave output. It consists of an inverting amplifier element such as a transistor or op amp with its output fed back to its input through a phase-shift network consisting of resistors and capacitors in a ladder network .
A linear amplifier is an electronic circuit whose output is proportional to its input, but capable of delivering more power into a load. The term usually refers to a type of radio-frequency (RF) power amplifier , some of which have output power measured in kilowatts , and are used in amateur radio .
He is known for designing the Phase Linear 700, at 350 W per channel the most powerful consumer audio amplifier available in 1972. He went on to found the Carver Corporation in 1979, Sunfire in 1994, and the Bob Carver LLC in 2011 [ 2 ] which was sold to Jade Design in June, 2013. [ 3 ]
Lighting and general purpose receptacles are at 120 volts AC, with larger devices fed by three wire single-phase circuits at 240 volts. In commercial construction, three-phase circuits are often used. Common 3 phase configurations within a building are 208v/120 wye, 120/240 center tapped delta and 480v/277v wye. Lighting is usually fed by 277 V ...
A bridge-tied load (BTL), also known as bridged transformerless and bridged mono, is an output configuration for audio amplifiers, a form of impedance bridging used mainly in professional audio & car applications. [1] The two channels of a stereo amplifier are fed the same monaural audio signal, with one channel's electrical polarity reversed.
Wiring is subject to safety standards for design and installation. Allowable wire and cable types and sizes are specified according to the circuit operating voltage and electric current capability, with further restrictions on the environmental conditions, such as ambient temperature range, moisture levels, and exposure to sunlight and chemicals.