Search results
Results from the WOW.Com Content Network
In Linux distributions based on 2.2.x Linux kernels, the ifconfig and route commands are operated together to connect a computer to a network, and to define routes between computer networks. Distributions based on later kernels have deprecated ifconfig and route, replacing them with iproute2. Route for Linux was originally written by Fred N ...
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
The default route in Internet Protocol Version 4 (IPv4) is designated as the zero address, 0.0.0.0 / 0 in CIDR notation. [2] Similarly, in IPv6, the default route is specified by :: / 0. The subnet mask is specified as / 0, which effectively specifies all networks and is the shortest match possible. A route lookup that does not match any other ...
Static routing may have the following uses: When using static address configuration (in the absence of DHCP or Router Advertisements) it can be used to provide a default route, forming a special case of the longest prefix match as it has a prefix length of zero and therefore always matches, and always matches last.
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...
The route will go in the direction of the gateway with the lowest metric. next hop: The next hop, or gateway, is the address of the next station to which the packet is to be sent on the way to its final destination; Depending on the application and implementation, it can also contain additional values that refine path selection:
The gateway is on the same network as end devices. The gateway address must have the same subnet mask as host devices. Each host on the network uses the same gateway. The gateway should have a static address, as changing the address would cause packets not to be delivered. The gateway is typically assigned either the highest or lowest network ...
Alpine Linux: Active: Linux distribution: x86, x86-64, ARM: Open source: Free: Linux distribution running from a RAM drive. Its original target was small appliances like routers, VPN gateways, or embedded x86 devices. However, it supports hosting other Linux guest OSes under LXC control, making it an attractive hosting solution as well. Uses ...