Search results
Results from the WOW.Com Content Network
The British, European and International standard for hot-dip galvanizing is BS EN ISO 1461, which specifies a minimum coating thickness to be applied to steel in relation to the steels section thickness e.g. a steel fabrication with a section size thicker than 6 mm shall have a minimum galvanized coating thickness of 85 μm.
ASTM A500 is a standard specification published by the ASTM for cold-formed welded and seamless carbon steel structural tubing in round, square, and rectangular shapes. It is commonly specified in the US for hollow structural sections , but the more stringent CSA G40.21 is preferred in Canada.
Production of galvannealed sheet steel begins with hot dip galvanization of sheet steel. After passing through the galvanizing zinc bath the sheet steel passes through air knives to remove excess zinc, and is then heated in an annealing furnace for several seconds causing iron and zinc layers to diffuse into one another causing the formation of zinc-iron alloy layers at the surface.
Scope of ASTM A53 Standard ASTM A53 is standard specification for pipe, steel, black and hot dipped, zinc-coated, welded and seamless. This specification covers seamless and welded black and hot-dipped galvanized steel pipe in NPS 1⁄8 to NPS 26 [DN 6 to DN 650] (Note 1), inclusive, with nominal wall thickness (Note 2) as given in Table X2.2 ...
An example of how the numbering system expands to provide additional detail below level 1 is shown for A SUBSTRUCTURE A10 FOUNDATIONS A1010 Standard Foundations A1020 Special Foundations A40 SLABS-ON-GRADE A4010 Standard Slabs-on-Grade A4020 Structural Slabs-on-Grade A4030 Slab Trenches A4040 Pits and Bases A4090 Slab-on-Grade Supplementary Components
A mill test report (MTR) and often also called a certified mill test report, certified material test report, mill test certificate (MTC), inspection certificate, certificate of test, or a host of other names, is a quality assurance document used in the metals industry that certifies a material's chemical and physical properties and states a product made of metal (steel, aluminum, brass or ...
The number is in the following format: x.yyzz(zz) Where x is the material type (only 1 is specified so far), yy is the steel group number (specified in EN10027-2) and zz(zz) is a sequential number designated by the certifying body, the number in brackets being unused but reserved for later use. The steel groups are indicated below:
The salt spray test (or salt fog test) is a standardized and popular corrosion test method, used to check corrosion resistance of materials and surface coatings.Usually, the materials to be tested are metallic (although stone, ceramics, and polymers may also be tested) and finished with a surface coating which is intended to provide a degree of corrosion protection to the underlying metal.