Search results
Results from the WOW.Com Content Network
Universal Software Radio Peripheral (USRP) is a range of software-defined radios designed and sold by Ettus Research and its parent company, National Instruments. Developed by a team led by Matt Ettus , the USRP product family is commonly used by research labs, universities, and hobbyists.
The software code is now open source and is developed by a small team. The program is designed for sending and receiving low-power transmissions to test propagation paths on the MF and HF bands. WSPR implements a protocol designed for probing potential propagation paths with low-power transmissions.
7.0–7.3 MHz/10.10–10.15 MHz, and 14.00–14.35 MHz ext No External ADC required (I/Q output) 1/1 Crystal controlled two channels Yes Yes Yes Cyan [33] Pre-built 100 kHz – 18 GHz 1 – 3 GHz (8 fully independent Rx chains and 8 fully independent Tx chains, each capable of up to 1 GHz of RF bandwidth) 16 16 Yes 1–3 GSPS ADCs
HackRF One is a wide band software defined radio (SDR) half-duplex transceiver created and manufactured by Great Scott Gadgets. It is able to send and receive signals. Its principal designer, Michael Ossmann, launched a successful Kickstarter campaign in 2014 with a first run of the project called HackRF. [1]
Logitech Unifying receiver (older) Logitech Unifying receiver (newer) Unifying logo The Logitech Unifying Receiver is a small dedicated USB wireless receiver, based on the nRF24L-family of RF devices, [1] that allows up to six compatible Logitech human interface devices (such as mice, trackballs, touchpads, and keyboards; headphones are not compatible) to be linked to the same computer using 2 ...
An RF receiver module receives the modulated RF signal, and demodulates it. There are two types of RF receiver modules: superheterodyne receivers and superregenerative receivers. Superregenerative modules are usually low cost and low power designs using a series of amplifiers to extract modulated data from a carrier wave.
In the simplest type of radio receiver, called a tuned radio frequency (TRF) receiver, the three functions above are performed consecutively: [9] (1) the mix of radio signals from the antenna is filtered to extract the signal of the desired transmitter; (2) this oscillating voltage is sent through a radio frequency (RF) amplifier to increase ...
The RF signal from the antenna may have one stage of amplification to improve the receiver's noise figure, although at lower frequencies this is typically omitted. The RF signal enters a mixer, along with the output of the local oscillator, in order to produce a so-called intermediate frequency (IF) signal. An early optimization of the ...