Search results
Results from the WOW.Com Content Network
List of free analog and digital electronic circuit simulators, available for Windows, macOS, Linux, and comparing against UC Berkeley SPICE. The following table is split into two groups based on whether it has a graphical visual interface or not.
Analog signature analysis is an electronic component and circuit board troubleshooting technique which applies a current-limited AC sine wave across two points of an electronic component or circuit. The resulting current/voltage waveform is shown on a signature display using vertical deflection for current and horizontal deflection for voltage.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
The two rows of holes (labelled #3) are test points used during the manufacture of this USB memory key. Testpoints on a printed circuit board (labelled E34, E35, E36, …) next to teardrop vias. A test point is a location within an electronic circuit that is used to monitor the state of the circuitry or inject test signals. [1]
A curve tracer is a specialised piece of electronic test equipment used to analyze the characteristics of discrete electronic components, such as diodes, transistors, thyristors, and vacuum tubes. The device contains voltage and current sources that can be used to stimulate the device under test (DUT).
SYSTEM REQUIREMENTS. Mobile and desktop browsers: Works best with the latest version of Chrome, Edge, FireFox and Safari. Windows: Windows 7 and newer Mac: MacOS X and newer Note: Ad-Free AOL Mail ...
A probe card or DUT board is a printed circuit board (PCB), and is the interface between the integrated circuit and a test head, which in turn attaches to automatic test equipment (ATE) (or "tester"). [2] Typically, the probe card is mechanically docked to a Wafer testing prober and electrically connected to the ATE . Its purpose is to provide ...
The tester has all these features and can check solid-state devices in and out of circuit. Transistor h fe varies fairly widely with Ic, so measurements with the service type tester give readings that can differ quite a bit from the h fe in the transistor's real life application.