Search results
Results from the WOW.Com Content Network
Triaxial cable, often referred to as triax for short, is a type of electrical cable similar to coaxial cable, but with the addition of an extra layer of insulation and a second conducting sheath. Triax provides greater bandwidth and rejection of interference than coax, but is more expensive.
The primary applicable specifications are MIL-C-39012 (relative to RF coaxial connectors such as BNC, N, etc.), MIL-C-49142 (related to concentric twinax/triax connectors) and MIL-DTL-38999 (related to military type cylindrical connectors). One of the most popular types of connectors used on the data bus is the concentric twinax bayonet style.
The connector systems that are commonly used with Eurocard architectures include the original DIN 41612 connector that is also standardized as IEC 60603.2. This is the connector that is used for the VMEbus standard, which was IEEE 1014. The connector known as the 5-row DIN, which is used for the VME64 Extensions standard is IEC 61076-4-113.
Typically the male connector is fitted to a cable, and the female to a panel on equipment. Cable connectors are often designed to be fitted by crimping [9] using a special power or manual tool. [10] [failed verification] Wire strippers which strip outer jacket, shield braid, and inner dielectric to the correct lengths in one operation are used ...
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
The connector looks almost identical to a typical BNC connector, but is designed to not mate with BNC jacks. It features two bayonet lugs on the female connector; mating is fully achieved with a quarter turn of the coupling nut. The dimensions of the connector are specified in the MIL-STD-348B. MHV connectors can be recognized by the slightly ...
A blind mate connector is a type of electrical connector that has a mating action that happens when sliding or snapping the plugs, without requiring wrenches or other tools. [1] They have self-aligning features which allows a small misalignment when mating.
The connector provides power to the keyboard on the outer two contacts and receives data signals on the inner pair. The cable between the computer and the keyboard is a coiled cord with an appearance very similar to a telephone handset cable. [11] The connector on the Amiga 1000 uses crossover wiring, similar to a telephone handset.