Search results
Results from the WOW.Com Content Network
90º miter joint (pieces ready to be joined) Miter joint of two pipes A miter joint (mitre in British English) is a joint made by cutting each of two parts to be joined, across the main surface, usually at a 45° angle, to form a corner, usually to form a 90° angle, though it can comprise any angle greater than 0 degrees.
In machining a chamfer is a slope cut at any right-angled edge of a workpiece, e.g. holes; the ends of rods, bolts, and pins; the corners of the long-edges of plates; any other place where two surfaces meet at a sharp angle. Chamfering eases assembly, e.g. the insertion of bolts into holes, or nuts.
Mason's mitre in a kitchen countertop. A mason's mitre is a type of mitre joint, traditionally used in stonework or masonry but commonly seen in kitchen countertops.In a mason's mitre, the two elements being joined meet as for a butt joint but a small section of one member is removed creating a socket to receive the end of the other.
Side views of a bevel (above) and a chamfer (below). A bevelled edge (UK) or beveled edge (US) is an edge of a structure that is not perpendicular to the faces of the piece. . The words bevel and chamfer overlap in usage; in general usage, they are often interchanged, while in technical usage, they may be differentiated as shown in the image on the ri
There are several types of butt joint based on the orientation of the pieces being joined. These include the T-butt, end-to-end butt, Miter butt and edge-to-edge butt. The T-butt joint is a very simple joint to construct. Members are simply docked (cut off) at a right angle and at the required length.
It is a square tiling with each edge chamfered into new hexagonal faces. It can also be seen as the intersection of two truncated square tilings with offset positions. And its appearance is similar to a truncated square tiling, except only half of the vertices have been truncated, leading to its descriptive name semitruncated square tiling .
A hand saw that has a steel reinforced spine to add rigidity and strength to the saw plate. Typically used in a miter (mitre) box, this saw is used for cross cuts. bandsaw A powered saw which utilizes a band of steel that has been joined at the ends to create a loop and has teeth cut into one edge.
The edge treatment for solid-surface countertops can be very elaborate. The material itself is usually only about 12 mm (1 ⁄ 2 in) thick so an edge is usually created by stacking up two or three layers of the material. The built-up edge then can be shaped to a rounded edge or an ogee. Fancier edge treatments are more expensive.