enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Twist-beam rear suspension - Wikipedia

   en.wikipedia.org/wiki/Twist-beam_rear_suspension

   Twist-beam rear suspension. The twist-beam rear suspension (also torsion-beam axle, deformable torsion beam, or compound crank) is a type of automobile suspension based on a large H- or C-shaped member. The front of the H attaches to the body via rubber bushings, and the rear of the H carries each stub-axle assembly, on each side of the car.

3. Torsion bar suspension - Wikipedia

   en.wikipedia.org/wiki/Torsion_bar_suspension

   Torsion bar suspension. Schematic of a front axle highlighted to show torsion bar. A torsion bar suspension, also known as a torsion spring suspension, is any vehicle suspension that uses a torsion bar as its main weight-bearing spring. One end of a long metal bar is attached firmly to the vehicle chassis; the opposite end terminates in a lever ...

4. Boat trailer - Wikipedia

   en.wikipedia.org/wiki/Boat_trailer

   Boat trailer. An empty boat trailer. A boat trailer is designed to launch, retrieve, carry and sometimes store boats. As of 2024, the cost of a boat trailer can be anywhere between $700 to $8000, depending on the size and number of axles the trailer has. [ 1]

5. Beam axle - Wikipedia

   en.wikipedia.org/wiki/Beam_axle

   A "live axle" not only connects two wheels, but also drives them. A beam axle, rigid axle, or solid axle is a dependent suspension design in which a set of wheels is connected laterally by a single beam or shaft. Beam axles were once commonly used at the rear wheels of a vehicle, but historically, they have also been used as front axles in four ...

6. Axle - Wikipedia

   en.wikipedia.org/wiki/Axle

   An axle or axletree is a central shaft for a rotating wheel or gear. On wheeled vehicles, the axle may be fixed to the wheels, rotating with them, or fixed to the vehicle, with the wheels rotating around the axle. [1] In the former case, bearings or bushings are provided at the mounting points where the axle is supported.

7. Trailing-arm suspension - Wikipedia

   en.wikipedia.org/wiki/Trailing-arm_suspension

   Trailing-arm designs in live axle setups often use just two or three links and a Panhard rod to locate the wheel laterally. A trailing arm design can also be used in an independent suspension arrangement. Each wheel hub is located only by a large, roughly triangular arm that pivots at one point, ahead of the wheel. Seen from the side, this arm ...