Search results
Results from the WOW.Com Content Network
Drill bit sizes are written as irreducible fractions. So, instead of 78/64 inch, or 1 14/64 inch, the size is noted as 1 7/32 inch. Below is a chart providing the decimal-fraction equivalents that are most relevant to fractional-inch drill bit sizes (that is, 0 to 1 by 64ths).
The Charrière is measured by the ''outer'' diameter, and is defined as 1 Fr = 1/3 mm, and thus 1 mm = 3 Fr; therefore the diameter of a round catheter in millimetres can be determined by dividing the French size by 3. [2] The French units roughly correspond to the outer circumference of the catheter (see table below).
Metric (SI) units. 25.4 mm. A fire hydrant marked as 3-inch. The inch (symbol: in or ″) is a unit of length in the British Imperial and the United States customary systems of measurement. It is equal to 1 36 yard or 1 12 of a foot. Derived from the Roman uncia ("twelfth"), the word inch is also sometimes used to translate ...
It is a transitional size with the shorter side of ISO A4 (210 mm, 8 + 1 ⁄ 4 inch) and the longer side of British Foolscap (13-inch, 330 mm). ISO A4 is exactly 90% the height of F4. This size is sometimes also known as (metric) 'foolscap' or 'folio'. In some countries, the narrow side of F4 is slightly broader: 8.5 inches (216 mm) or 215 mm.
The Reagan administration made Letter-size paper the norm for US federal forms in the early 1980s; previously, the smaller "official" Government Letter size, 8 by 10.5 inches (203.2 by 266.7 mm) (aspect ratio: 1.3125), was used in government, while 8.5-by-11-inch (215.9 by 279.4 mm) paper was standard in most other offices. [2]
Horizontal pitch (HP) is a unit of length defined by the Eurocard printed circuit board standard used to measure the horizontal width of rack mounted electronic equipment, similar to the rack unit (U) used to measure vertical heights of rack mounted equipment. One HP is 0.2 inches (1/5") or 5.08 millimetres wide.
typographic units. ≈ 0.709 pts. metric points. 0.66 6 nd. inches. ≈ 0.009 84 in. Also in the 1970s, the new unit quart (quarter millimetre, abbreviated 'q') of 250 μm (1⁄4 mm) was devised. [1] The German draft standard DIN 16507-2 has suggested that digital typography will be specified using millimeters, with sizes in multiples of 0.250 mm.
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...