Search results
Results from the WOW.Com Content Network
For example, on a certain monitor, the horizontal distance between the upper limits for parathyroid hormone in pmol/L and pg/mL may be 7 cm, with the mass concentration to the right. A molar concentration of, for example, 5 pmol/L would therefore correspond to a mass concentration located 7 cm to the right in the mass diagram, that is ...
Molar concentration (also called molarity, amount concentration or substance concentration) is a measure of the concentration of a chemical species, in particular, of a solute in a solution, in terms of amount of substance per unit volume of solution. In chemistry, the most commonly used unit for molarity is the number of moles per liter ...
In chemistry, the molar absorption coefficient or molar attenuation coefficient (ε) [1] is a measurement of how strongly a chemical species absorbs, and thereby attenuates, light at a given wavelength. It is an intrinsic property of the species. The SI unit of molar absorption coefficient is the square metre per mole (m2/mol), but in practice ...
The molar conductivity of an electrolyte solution is defined as its conductivity divided by its molar concentration. [1][2] where: κ is the measured conductivity (formerly known as specific conductance), [3] c is the molar concentration of the electrolyte. The SI unit of molar conductivity is siemens metres squared per mole (S m 2 mol −1). [2]
As the concentration is increased however, the conductivity no longer rises in proportion. Moreover, Kohlrausch also found that the limiting conductivity of an electrolyte; λ 0 + and λ 0 − are the limiting molar conductivities of the individual ions. The following table gives values for the limiting molar conductivities for some selected ...
According to the American Diabetes Association, the fasting blood glucose target range for diabetics, should be 3.9 - 7.2 mmol/L (70 - 130 mg/dL) and less than 10 mmol/L (180 mg/dL) two hours after meals (as measured by a blood glucose monitor). [6][7][9] Normal value ranges may vary slightly between laboratories.
Orders of magnitude (molar concentration) This page lists examples of the orders of magnitude of molar concentration. Source values are parenthesized where unit conversions were performed. M denotes the non-SI unit molar: 1 M = 1 mol/L = 10 −3 mol/m 3.
For example, sulfuric acid (H 2 SO 4) is a diprotic acid. Since only 0.5 mol of H 2 SO 4 are needed to neutralize 1 mol of OH −, the equivalence factor is: feq (H 2 SO 4) = 0.5. If the concentration of a sulfuric acid solution is c (H 2 SO 4) = 1 mol/L, then its normality is 2 N. It can also be called a "2 normal" solution.