enow.com Web Search

  1. Ads

    related to: garboard drain plugs for boats

Search results

  1. Results from the WOW.Com Content Network
  2. Strake - Wikipedia

    en.wikipedia.org/wiki/Strake

    Strake. A clinker-built Viking longship, whose overlapping planks constitute "strakes". On a vessel's hull, a strake is a longitudinal course of planking or plating which runs from the boat's stempost (at the bows) to the sternpost or transom (at the rear). The garboard strakes are the two immediately adjacent to the keel on each side.

  3. Boat building - Wikipedia

    en.wikipedia.org/wiki/Boat_building

    Boat building. Boat building is the design and construction of boats (instead of the larger ships) — and their on-board systems. This includes at minimum the construction of a hull, with any necessary propulsion, mechanical, navigation, safety and other service systems as the craft requires. [1]

  4. Longship - Wikipedia

    en.wikipedia.org/wiki/Longship

    A drain plug hole about 25 mm (1 inch) was drilled in the garboard plank on one side to allow rain water drainage. The oars did not use rowlocks or thole pins but holes cut below the gunwale line. To keep seawater out, these oar holes were sealed with wooden disks from the inside, when the oars were not in use.

  5. Deck (ship) - Wikipedia

    en.wikipedia.org/wiki/Deck_(ship)

    As is typical for a late-19th-century vessel, several deckhouses may be seen. A deck is a permanent covering over a compartment or a hull [1] of a ship. On a boat or ship, the primary or upper deck is the horizontal structure that forms the "roof" of the hull, strengthening it and serving as the primary working surface.

  6. Limber hole - Wikipedia

    en.wikipedia.org/wiki/Limber_hole

    Limber hole. A limber hole is a drain hole through a frame or other structural member of a boat designed to prevent water from accumulating against one side of the frame, and allowing it to drain toward the bilge. Limber holes are common in the bilges of wooden boats. The term may be extended to cover drain holes in floors.

  7. Bilge - Wikipedia

    en.wikipedia.org/wiki/Bilge

    Bilge. The bilge / bɪldʒ / of a ship or boat is the part of the hull that would rest on the ground if the vessel were unsupported by water. The "turn of the bilge" is the transition from the bottom of a hull to the sides of a hull. Internally, the bilges (usually used in the plural in this context) is the lowest compartment on a ship or ...

  1. Ads

    related to: garboard drain plugs for boats