Search results
Results from the WOW.Com Content Network
Each cable has two or three connectors, one of which plugs into a host adapter interfacing with the rest of the computer system. The remaining connector(s) plug into storage devices, most commonly hard disk drives or optical drives. Each connector has 39 physical pins arranged into two rows (2.54 mm, 1 ⁄ 10-inch pitch), with a gap or key at ...
Modern bit serial interfaces connect a hard disk drive to a host bus interface adapter (today in a PC typically integrated into the "south bridge") with one data/control cable. Each drive also has an additional power cable, usually direct to the power supply unit.
The power connector was typically the same 4-pin female Molex connector used in many other internal computer devices. The communication connectors on the drives were usually a 50 (for 8-bit SCSI) or 68 pin male (for 16-bit SCSI) "IDC header" which has two rows of pins, 0.1 inches apart.
Small Computer System Interface (SCSI, / ˈ s k ʌ z i / SKUZ-ee) [2] is a set of standards for physically connecting and transferring data between computers and peripheral devices, best known for its use with storage devices such as hard disk drives.
Hence, its protocol is usually ATA (a.k.a. PATA), SATA, SCSI, FC or SAS. The front-end interface communicates with a computer's host adapter (HBA, Host Bus Adapter) and uses: one of ATA, SATA, SCSI, FC; these are popular protocols used by disks, so by using one of them a controller may transparently emulate a disk for a computer.
SATA specifies a different power connector than the four-pin Molex connector used on Parallel ATA (PATA) devices (and earlier small storage devices, going back to ST-506 hard disk drives and even to floppy disk drives that predated the IBM PC). It is a wafer-type connector, like the SATA data connector, but much wider (fifteen pins versus seven ...
Example of a klm digital I/O expansion card using a large square chip from PLX Technology to handle the PCI bus interface PCI expansion slot Altair 8800b from March 1976 with an 18-slot S-100 backplane which housed both the Intel 8080 mainboard and many expansion boards Rack of IBM Standard Modular System expansion cards in an IBM 1401 computer using a 16-pin gold plated edge connector first ...
M.2, pronounced m dot two [1] and formerly known as the Next Generation Form Factor (NGFF), is a specification for internally mounted computer expansion cards and associated connectors. M.2 replaces the Mini SATA ( mSATA ) standard and the Mini PCIe ( mPCIe ) standard (which is how it got the short name of M dot 2 from being Mini SATA 2).