Search results
Results from the WOW.Com Content Network
On Windows computers, the gateway address is configured using the TCP/IP Properties. The gateway address can be automatically determined using Dynamic Host Configuration Protocol (DHCP). DHCP allows a host to obtain network information from a server. The host contacts the server to obtain an IP address and Default Gateway address.
TCP/IP defines the addresses 192.168.4.0 (network ID address) and 192.168.4.255 (broadcast IP address). The office's hosts send packets to addresses within this range directly, by resolving the destination IP address into a MAC address with the Address Resolution Protocol (ARP) sequence and then encapsulates the IP packet into a MAC frame ...
On an Internet Protocol (IP) network, IP packets with a destination outside a given subnetwork are sent to the network gateway. For example, if a private network has a base IPv4 address of 192.168.1.0 and has a subnet mask of 255.255.255.0, then any data addressed to an IP address outside of 192.168.1.0–192.168.1.255 is sent to the network ...
The IP address of the selected router is ... Given a destination IP address, D, and network ... Kernel IP routing table Destination Gateway Genmask Flags Metric Ref ...
The network with the longest subnet mask or network prefix that matches the destination IP address is the next-hop network gateway. The process repeats until a packet is delivered to the destination host, or earlier along the route, when a router has no default route available and cannot route the packet otherwise.
A router is considered a layer-3 device because its primary forwarding decision is based on the information in the layer-3 IP packet, specifically the destination IP address. When a router receives a packet, it searches its routing table to find the best match between the destination IP address of the packet and one of the addresses in the ...
On Windows XP, the server, by default, gets the IP address 192.168.0.1. (This default can be changed within the interface settings of the network adapter or in the Windows Registry .) It provides NAT services to the entire 192.168.0.x subnet, even if the address on the client was set manually, not by the DHCP server.
Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private network Used for local communications within a private network [3] 192.0.0.0/24 192.0.0.0–192.0.0.255 256