Search results
Results from the WOW.Com Content Network
Square rig is a generic type of sail and rigging arrangement in which the primary driving sails are carried on horizontal spars which are perpendicular, or square, to the keel of the vessel and to the masts. These spars are called yards and their tips, outside the lifts, are called the yardarms. [1] A ship mainly rigged so is called a square ...
A sail plan is a drawing of a sailing craft, viewed from the side, depicting its sails, the spars that carry them and some of the rigging that supports the rig. [1] By extension, "sail plan" describes the arrangement of sails on a craft. [2] [3] A sailing craft may be waterborne (a ship or boat), an iceboat, or a sail-powered land vehicle.
Clewlines and buntlines are lines used to handle the sails of a square rigged ship. The leechlines are clearly visible running inwards and upwards from the edges of the sail. The buntlines up the front of the sail can be seen too, but their run to the blocks on the shrouds is obscured because the sail is set on a lifting yard.
A square-rig mainsail is a square sail attached at the bottom of the main mast. A Bermuda-rig mainsail is a triangular sail with the luff attached to the mast with the foot or lower edge generally attached to a boom. A gaff-rig mainsail is a quadrilateral sail whose head is supported by a gaff.
Re-rigging a brigantine with two square-rigged masts instead of one gave it greater sailing power. The square-rigged brig's advantage over the fore-and-aft rigged brigantine was "that the sails, being smaller and more numerous, are more easily managed, and require fewer men or 'hands' to work them."
Square sail edges and corners (top). Running rigging (bottom). Sailing ships have standing rigging to support the masts and running rigging to raise the sails and control their ability to draw power from the wind. The running rigging has three main roles, to support the sail structure, to shape the sail and to adjust its angle to the wind.
Running rigging on a sailing yacht: 1. Main sheet 2. Jib sheet 3. Boom vang 4. Downhaul 5. Jib halyard. Rigging comprises the system of ropes, cables and chains, which support and control a sailing ship or sail boat's masts and sails. Standing rigging is the fixed rigging that supports masts including shrouds and stays. Running rigging is ...
The lowest and normally largest sail on a mast is the course sail of that mast, and is referred to simply by the mast name: Foresail, mainsail, mizzen sail, jigger sail or more commonly forecourse etc. Even a full-rigged ship did not usually have a lateral (square) course on the mizzen mast below the mizzen topmast.