Search results
Results from the WOW.Com Content Network
Example 2: Consider a larger block of the same stone material as in Example 1 but with a 1-liter cavity inside of the same amount of stone. The block would still weigh 3 kilograms on dry land (ignoring the weight of air in the cavity) but it would now displace 2 liters of water so its immersed weight would be only 1 kilogram (at 4 °C).
An important parameter in wet scrubbing systems is the rate of liquid flow. It is common in wet scrubber terminology to express the liquid flow as a function of the gas flow rate that is being treated. This is commonly called the liquid-to-gas ratio (L/G ratio) and uses the units of gallons per 1,000 actual cubic feet or litres per cubic metre ...
The weight of the displaced fluid can be found mathematically. The mass of the displaced fluid can be expressed in terms of the density and its volume, m = ρV. The fluid displaced has a weight W = mg, where g is acceleration due to gravity. Therefore, the weight of the displaced fluid can be expressed as W = ρVg.
Brine draw: Water is directed through a jet pump, which pulls salt water from the brine tank, before the water and brine pass through the resin bed in the normal direction, if co-current, or in the reverse direction, if counter-current. [12] The output of this typically thirty-minute process is discarded through the drain hose.
A Horton sphere (sometimes spelled Hortonsphere), also referred to as a spherical tank or simply sphere, is a spherical pressure vessel, which is used for industrial-scale storage of liquefied gases. Example of materials that can be stored in Horton spheres are liquefied petroleum gas (LPG), liquefied natural gas (LNG), and anhydrous ammonia .
W water is the weight of the sample in water (measured in the same units). This technique cannot easily be used to measure relative densities less than one, because the sample will then float. W water becomes a negative quantity, representing the force needed to keep the sample underwater. Another practical method uses three measurements.
A gas cylinder is used to store gas or liquefied gas at pressures above normal atmospheric pressure. [2] In South Africa, a gas storage cylinder implies a refillable transportable container with a water capacity volume of up to 150 litres. Refillable transportable cylindrical containers from 150 to 3,000 litres water capacity are referred to as ...
A gas holder or gasholder, also known as a gasometer, is a large container in which natural gas or town gas (coal gas or formerly also water gas) is stored near atmospheric pressure at ambient temperatures. The volume of the container follows the quantity of stored gas, with pressure coming from the weight of a movable cap.