Search results
Results from the WOW.Com Content Network
The hydraulic gradient is the rate of change of total head with distance. The total head, at a point is defined as the height (measured relative to the datum) to which water would rise in a piezometer at that point. The total head is related to the excess water pressure by:
Wind throw is the toppling of a tree due to the force of the wind, this exposes the root plate and adjacent soil beneath the tree and influences slope stability. Wind throw is a factor when considering one tree on a slope; however, it is of lesser importance when considering general slope stability for a body of trees as the wind forces involved represent a smaller percentage of the potential ...
The first modern theoretical models for soil consolidation were proposed in the 1920s by Terzaghi and Fillunger, according to two substantially different approaches. [1] The former was based on diffusion equations in eulerian notation, whereas the latter considered the local Newton’s law for both liquid and solid phases, in which main variables, such as partial pressure, porosity, local ...
New soils increase in depth by a combination of weathering and further deposition. The soil production rate due to weathering is approximately 1/10 mm per year. [5] New soils can also deepen from dust deposition.
The specific heat of soil increases as water content increases, since the heat capacity of water is greater than that of dry soil. [89] The specific heat of pure water is ~ 1 calorie per gram, the specific heat of dry soil is ~ 0.2 calories per gram, hence, the specific heat of wet soil is ~ 0.2 to 1 calories per gram (0.8 to 4.2 kJ per ...
The reduction of weathering rate with thickening of soil is related to the exponential decrease of temperature amplitude with increasing depth below the soil surface, and also the exponential decrease in average water penetration (for freely-drained soils). Parameters P 0 and k are related to the climate and type of parent material.
The available volume for additional water in the soil depends on the porosity of the soil [7] and the rate at which previously infiltrated water can move away from the surface through the soil. The maximum rate at that water can enter soil in a given condition is the infiltration capacity.
The name cam clay asserts that the plastic volume change typical of clay soil behaviour is due to mechanical stability of an aggregate of small, rough, frictional, interlocking hard particles. [3] The Original Cam-Clay model is based on the assumption that the soil is isotropic, elasto-plastic, deforms as a continuum, and it is not affected by ...