Search results
Results from the WOW.Com Content Network
Example of a radio map estimate using STORM, a transformer-based radio map estimator. Signal strength maps quantify signal strength at each location. Formally, a signal strength map can be seen as a function γ ( r ) {\displaystyle \gamma (\mathbf {r} )} that provides a signal strength metric for each location r {\displaystyle \mathbf {r} } .
A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .
The advantage of this approach is that the coverage maps show network reach and performance as it is experienced by its users. Often companies will construct low power satellite stations to fill in bad reception areas that become apparent once the high power transmitter's coverage map has identified where the network is deficient.
In radio this device is also known as a dummy antenna or a radio frequency termination. It is a device, usually a resistor , used in place of an antenna to aid in testing a radio transmitter . It is substituted for the antenna while one adjusts the transmitter, so that no radio waves are radiated so that the transmitter does not interfere with ...
The Time from NPL is a radio signal broadcast from the Anthorn Radio Station near Anthorn, Cumbria, which serves as the United Kingdom's national time reference. [1] The time signal is derived from three atomic clocks installed at the transmitter site, and is based on time standards maintained by the UK's National Physical Laboratory (NPL) in Teddington. [2]
In the following there are lists of sites of notable radio transmitters. During the early history of radio many countries had only a few high power radio stations, operated either by the government or large corporations, which broadcast to the population or to other countries. Because of the large number of transmission sites, this list is not ...
The act of measuring the direction is known as radio direction finding or sometimes simply direction finding (DF). Using two or more measurements from different locations, the location of an unknown transmitter can be determined; alternately, using two or more measurements of known transmitters, the location of a vehicle can be determined.
In a radio antenna, the feed line (feedline), or feeder, is the cable or other transmission line that connects the antenna with the radio transmitter or receiver.In a transmitting antenna, it feeds the radio frequency (RF) current from the transmitter to the antenna, where the energy in the current is radiated as radio waves.