Search results
Results from the WOW.Com Content Network
These non-mechanical prime movers engage a turbine that is coupled to a generator. Generators that employ the principle of electro-magnetic induction carry out the final conversion of these energy sources. In order to do this, three necessary conditions must exist before a voltage is created by magnetism: movement, conductors and a magnetic field.
More expensive and less common but more efficient is the hub dynamo that rotates neodymium magnets around a copper coil in a claw pole cage inside the hub of a wheel. Commonly referred to as dynamos , both devices are in fact magnetos, producing alternating current as opposed to the direct current produced by a true dynamo .
A protective or other coating covered each entire plate. A copper plate could be coated with powdered coke, a processed carbonaceous material. To a zinc plate, a layer of felt could be applied. To use the natural electricity, earth batteries fed electromagnets, the load, that were part of a motor mechanism. [citation needed]
An ignition magneto (also called a high-tension magneto) is an older type of ignition system used in spark-ignition engines (such as petrol engines). It uses a magneto and a transformer to make pulses of high voltage for the spark plugs. The older term "high-tension" means "high-voltage". [1]
Within two months, Faraday had found several other manifestations of electromagnetic induction. For example, he saw transient currents when he quickly slid a bar magnet in and out of a coil of wires, and he generated a steady current by rotating a copper disk near the bar magnet with a sliding electrical lead ("Faraday's disk").
The artifacts consist of a terracotta pot approximately 140 mm (6 in) tall, with a 38 mm (1.5 in) mouth, containing a cylinder made of a rolled copper sheet, which houses a single iron rod. At the top, the iron rod is isolated from the copper by bitumen, with plugs or stoppers, and both rod and cylinder fit snugly inside the opening of the jar ...
"Egg of Columbus" demonstration at the 1893 Columbian Exposition. Tesla's Egg of Columbus was a device exhibited in the Westinghouse Electric display at the 1893 Chicago World's Columbian Exposition to explain the rotating magnetic field that drove the new alternating current induction motors designed by inventor Nikola Tesla by using that magnetic field to spin a copper egg on end.
Electrostatic machines are typically used in science classrooms to safely demonstrate electrical forces and high voltage phenomena. The elevated potential differences achieved have been also used for a variety of practical applications, such as operating X-ray tubes, particle accelerators, spectroscopy, medical applications, sterilization of food, and nuclear physics experiments.