enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Transmission control unit - Wikipedia

   en.wikipedia.org/wiki/Transmission_Control_Unit

   These electronic systems typically work in conjunction with the engine control unit (in a similar way to road cars), and are responsible for operating electronic throttle control, clutch and gearshift actuation (via an electric, hydraulic, or pneumatic actuator), gearshift time and speed, sensors, switches, solenoids, and other hydraulic ...

3. Engine control unit - Wikipedia

   en.wikipedia.org/wiki/Engine_control_unit

   An engine control unit (ECU), also called an engine control module (ECM), [1] is a device that controls various subsystems of an internal combustion engine. Systems commonly controlled by an ECU include the fuel injection and ignition systems.

4. Electronic throttle control - Wikipedia

   en.wikipedia.org/wiki/Electronic_throttle_control

   A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]

5. Traction control system - Wikipedia

   en.wikipedia.org/wiki/Traction_control_system

   The predecessor of modern electronic traction control systems can be found in high-torque, high-power rear-wheel-drive cars as a limited slip differential.A limited-slip differential is a purely mechanical system that transfers a relatively small amount of power to the non-slipping wheel, while still allowing some wheel spin to occur.

6. Ford EEC - Wikipedia

   en.wikipedia.org/wiki/Ford_EEC

   EEC-III on carbureted cars controlled the same Ford 7200 VV carburetor as the EEC-II. On fuel-injected cars, the module fired two high pressure (approximately 40 psi) fuel injectors that were mounted in a throttle body attached to a traditional intake manifold in the center valley of the 5.0 liter (302 cid) engine.

7. Automotive hacking - Wikipedia

   en.wikipedia.org/wiki/Automotive_hacking

   Modern automobiles contain hundreds of on-board computers processing everything from vehicle controls to the infotainment system. These computers, called Electronic control units (ECU), communicate with each other through multiple networks and communication protocols including the Controller Area Network (CAN) for vehicle component communication such as connections between engine and brake ...

8. Motronic - Wikipedia

   en.wikipedia.org/wiki/Motronic

   What made this ECU special was the use of two crank sensors and one cam sensor. The ECU used one crank sensor to count the teeth on the starter ring for its RPM signal, and the other read a pin on the back of the flywheel for TDC reference. This ECU was first seen when the 20V turbo 5-cylinder engine (RR Code) was installed into the Audi Quattro.

9. Unified Diagnostic Services - Wikipedia

   en.wikipedia.org/wiki/Unified_Diagnostic_Services

   ECU Reset The service "ECU reset" is used to restart the control unit (ECU). Depending on the control unit hardware and implementation, different forms of reset can be used: 0x11 01 Hard Reset simulates a shutdown of the power supply. 0x11 02 key Off-On Reset simulates the drain and turn on the ignition with the key.