Search results
Results from the WOW.Com Content Network
It is a rigid type of support or connection. The application of the fixed support is beneficial when we can only use single support, and people most widely used this type as the only support for a cantilever. [7] They are common in beam-to-column connections of moment-resisting steel frames and beam, column and slab connections in concrete frames.
Moment-resisting frame is a rectilinear assemblage of beams and columns, with the beams rigidly connected to the columns. Resistance to lateral forces is provided primarily by rigid frame action – that is, by the development of bending moment and shear force in the frame members and joints. By virtue of the rigid beam–column connections, a ...
The gusset plate is welded to a beam, and then two or three columns, beams, or truss chord are connected to the other side of the gusset plate through bolts or rivets or welds. [3] A uniform force bracing connection connects a beam, column, and one other member. The gusset plate is bolted to the column and welded to the beam.
Portal frame is a construction technique where vertical supports are connected to horizontal beams or trusses via fixed joints with designed-in moment-resisting capacity. [1] The result is wide spans and open floors. Portal frame structures can be constructed using a variety of materials and methods.
Therefore, the connection of the braces to beams and columns can greatly affect the performance of the brace in the case of a seismic event. Typically, the brace is attached to a gusset plate, which in turn is welded to the beam and/or column that the brace will be attached to. Usually three types of connections are used for BRBs:
The columns are identical, apart from the boundary conditions. A conclusion from the above is that the buckling load of a column may be increased by changing its material to one with a higher modulus of elasticity (E), or changing the design of the column's cross section so as to increase its moment of inertia.
In the structural engineering beam theory, plastic hinge is the deformation of a section of a beam where plastic bending occurs. [1] In earthquake engineering plastic hinge is also a type of energy damping device allowing plastic rotation [deformation] of an otherwise rigid column connection. [2]
The secant stiffness of the connection is compared to the rotational stiffness of the connected member as follows, in which L and EI are the length and bending rigidity, respectively, of the beam. If K s L/EI ≥ 20, it is acceptable to consider the connection to be fully restrained (in other words, able to maintain the angles between members).