Search results
Results from the WOW.Com Content Network
The working face of the suction cup is made of elastic, flexible material and has a curved surface. [3] When the center of the suction cup is pressed against a flat, non-porous surface, the volume of the space between the suction cup and the flat surface is reduced, which causes the air or water between the cup and the surface to be expelled past the rim of the circular cup.
Suction pumps are also used with a suction head appropriate for each part to pick up and remove tiny surface mount devices once solder has melted, and to place parts. Hot air pumps blow air hot enough to melt all the solder around a small surface mounted part, and can be used for soldering parts in place, and for desoldering followed by removal ...
As the steam condensed in one chamber, it acted as a suction pump, while in the other chamber, steam was introduced under pressure and so it acted as a force pump. At the end of every stroke, a ball valve consisting of a small brass ball moved slightly, causing the two chambers to swap functions from suction-pump to force-pump and vice versa ...
Diagram of the vacuum filtration apparatus. By flowing through the aspirator, water will suck out the air contained in the vacuum flask and the Büchner flask.There is therefore a difference in pressure between the exterior and the interior of the flasks : the contents of the Büchner funnel are sucked towards the vacuum flask.
The line of sucker rods is represented in this diagram by the solid black line in the center of the well. A sucker rod is a steel rod, typically between 7 and 9 metres (25 and 30 ft) in length, and threaded at both ends, used in the oil industry to join together the surface and downhole components of a reciprocating piston pump installed in an oil well.
With the pump, no external suction (e.g. from a person's mouth/lungs) is required to start the siphon and thus the product is described as a "self-siphon". If the upper reservoir is such that the liquid there can rise above the height of the siphon crest, the rising liquid in the reservoir can "self-prime" the siphon and the whole apparatus be ...
A pulser pump makes use of water that flows through pipes and an air chamber from an upper reservoir to a lower reservoir. The intake is a trompe, which uses water flow to pump air to a separation chamber; air trapped in the chamber then drives an airlift pump. The top of the pipe that connects the upper reservoir to the air chamber is ...
Conventional airlift pumps have a flow rate that is very limited. The pump is either on or off. It is very difficult to get a wide range of proportional flow control by varying the volume of compressed air. This is a dramatic disadvantage in some parts of a small wastewater treatment plant, such as the aerator. [5] the suction is limited.