Search results
Results from the WOW.Com Content Network
The working face of the suction cup is made of elastic, flexible material and has a curved surface. [3] When the center of the suction cup is pressed against a flat, non-porous surface, the volume of the space between the suction cup and the flat surface is reduced, which causes the air or water between the cup and the surface to be expelled past the rim of the circular cup.
Screwfix Direct Limited, trading as Screwfix, is a retailer of trade tools, accessories and hardware products based in the United Kingdom. [6] Founded in 1979 as the Woodscrew Supply Company, the company was acquired in July 1999 by Kingfisher plc , which also owns B&Q , and is listed on the London Stock Exchange .
Diagram of the vacuum filtration apparatus. By flowing through the aspirator, water will suck out the air contained in the vacuum flask and the Büchner flask.There is therefore a difference in pressure between the exterior and the interior of the flasks : the contents of the Büchner funnel are sucked towards the vacuum flask.
The suction excavator uses suction fans for the airflow to suck up the material that is then transported into the holding tank. Hydro excavation , a type of suction excavator using high-pressure water jets , is sometimes referred to as daylighting , as the underground utilities are exposed to daylight during the process. [ 2 ]
The line of sucker rods is represented in this diagram by the solid black line in the center of the well. A sucker rod is a steel rod, typically between 7 and 9 metres (25 and 30 ft) in length, and threaded at both ends, used in the oil industry to join together the surface and downhole components of a reciprocating piston pump installed in an oil well.
If the pump casing becomes filled with vapors or gases, the pump impeller becomes gas-bound and incapable of pumping. [10] To ensure that a centrifugal pump remains primed and does not become gas-bound, most centrifugal pumps are located below the level of the source from which the pump is to take its suction.
At the end of every stroke, a ball valve consisting of a small brass ball moved slightly, causing the two chambers to swap functions from suction-pump to force-pump and vice versa. The result was that the water was first suction pumped and then force pumped. [4] A good explanation can be found in the 1901 article referenced below:
A Büchner funnel with a sintered glass disc. A Büchner funnel is a piece of laboratory equipment used in filtration. [1] It is traditionally made of porcelain, but glass and plastic funnels are also available. On top of the funnel-shaped part there is a cylinder with a fritted glass disc/perforated