Search results
Results from the WOW.Com Content Network
The damaged transistor shows a low-ohmic junction between gate and drain terminals. A parametric failure only shifts the device parameters and may manifest in stress testing; sometimes, the degree of damage can lower over time. Latent ESD failure modes occur in a delayed fashion and include: Insulator damage by weakening of the insulator ...
To remove and recover all components, both through-hole and surface-mount, from a board which itself is usually no longer needed, a flame or hot air gun can be used to rapidly heat all parts so they can be pulled off. Parts may be damaged, and toxic fumes emitted, if excessive temperature or prolonged heating is used.
Reverse bias: Although the LED is based on a diode junction and is nominally a rectifier, the reverse-breakdown mode for some types can occur at very low voltages and essentially any excess reverse bias can cause immediate degradation, and may lead to vastly accelerated failure. 5 V is a typical maximum reverse bias voltage specification for ...
Light can be used to transmit data and analog signals. For example, lighting white LEDs can be used in systems assisting people to navigate in closed spaces while searching necessary rooms or objects. [100] Assistive listening devices in many theaters and similar spaces use arrays of infrared LEDs to send sound to listeners' receivers.
This allows all light to pass through to the RGB layer, creating a bright pixel that is always on. Another cause of bright dot may be the presence of impurities in the liquid crystal. On the one hand, impurities will affect the alignment of liquid crystal molecules, and on the other hand, they can reflect light to form bright spots.
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
The device may have the form of a screwdriver. The tip of the tester is touched to the conductor being tested (for instance, it can be used on a wire in a switch, or inserted into a hole of an electric socket). A neon lamp takes very little current to light, and thus can use the user's body capacitance to earth ground to complete the circuit.
A group of tell-tales showing lights for "brake fluid", "stop lamp" and "check engine" Graphical tell-talesA tell-tale, sometimes called an idiot light [1] or warning light, is an indicator of malfunction or operation of a system, indicated by a binary (on/off) illuminated light, symbol or text legend.