Search results
Results from the WOW.Com Content Network
Ken Fischer designed and built his amps solely as amp heads, not combos. [1] [9] This was done to prolong the service life of the vacuum tubes. Trainwreck amplifiers are housed in their signature polished wood cabinets. By customer request, a custom engraving can be added to the control panel.
A control panel is a flat, often vertical, area where control or monitoring instruments are displayed or it is an enclosed unit that is the part of a system [1] that users can access, such as the control panel of a security system (also called control unit).
A plugboard or control panel (the term used depends on the application area) is an array of jacks or sockets (often called hubs) into which patch cords can be inserted to complete an electrical circuit. Control panels are sometimes used to direct the operation of unit record equipment, cipher machines, and early computers. The array of holes is ...
Typical instrumentation amplifier schematic. An instrumentation amplifier (sometimes shorthanded as in-amp or InAmp) is a type of differential amplifier that has been outfitted with input buffer amplifiers, which eliminate the need for input impedance matching and thus make the amplifier particularly suitable for use in measurement and test equipment.
In the sense used in this paragraph, bootstrapping an operational amplifier means "using a signal to drive the reference point of the op-amp's power supplies". [5] A more sophisticated use of this rail bootstrapping technique is to alter the non-linear C/V characteristic of the inputs of a JFET op-amp in order to decrease its distortion. [6] [7]
The ES212 was similar but with 12 radiators. and crossover at 375 Hz. The ES26 featured 6 radiators with two 10" woofers, and the ES14 had 4 radiators with one 10" woofer, both with crossovers at 1500 Hz. The large subwoofers, in conjunction with the electrostatic panels, provided audio response stated variously as 22-30 Hz up to 30 kHz.
Coded panels were the earliest type of central fire alarm control, and were made during the 1800s to the 1970s. A coded panel is similar in many ways to a modern conventional panel (described below), except each zone was connected to its own code wheel, which, depending on the way the panel was set up, would either do sets of four rounds of code until the initiating pull station was reset ...
In large buildings, a fire alarm control panel is located in a secure location, such as in an electrical room where it is also convenient for running electrical wires for system components or in a fire command center. A fire alarm annunciator panel is located where it is accessible to fire-fighting crews, such as at building entrances/exits.