enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Bass reflex - Wikipedia

    en.wikipedia.org/wiki/Bass_reflex

    Two-inch port tube installed in the top of a Polk S10 speaker cabinet as part of a DIY audio project. This port is flared. Unlike closed-box loudspeakers, which are nearly airtight, a bass reflex system has an opening called a port or vent cut into the cabinet, generally consisting of a pipe or duct (typically circular or rectangular cross section).

  3. Thiele/Small parameters - Wikipedia

    en.wikipedia.org/wiki/Thiele/Small_parameters

    A common use of Thiele/Small parameters is in designing PA system and hi-fi speaker enclosures; the TSP calculations indicate to the speaker design professionals how large a speaker cabinet will need to be and how large and long the bass reflex port (if it is used) should be.

  4. Bass amplifier - Wikipedia

    en.wikipedia.org/wiki/Bass_amplifier

    This was a 26-watt tube amplifier with a single 15" speaker. In 1954, the Bassman was redesigned to use four 10" speakers. This speaker cabinet was an open-back design; as such, it had poor low-frequency efficiency and was prone to blowing speakers when used for bass because of the lack of damping.

  5. Loudspeaker enclosure - Wikipedia

    en.wikipedia.org/wiki/Loudspeaker_enclosure

    These designs can be considered a mass-loaded transmission line design or a bass reflex design, as well as a quarter wave enclosure. [38] Quarter wave resonators have seen a revival as commercial applications with the onset of neodymium drivers that enable this design to produce relatively low bass extensions within a relatively small speaker ...

  6. Linn Isobarik - Wikipedia

    en.wikipedia.org/wiki/Linn_Isobarik

    This 2-way, 4-ohm, design was a physically much smaller product – measuring 425 × 332 × 244 mm (16.7 × 13.1 × 9.6 in) – that required tall speaker stands. Launched in 1978, it was Linn's entry-level loudspeaker until the Kan (a non-isobaric bookshelf speaker using the same Linn D20-LP-1 and KEF B110 drive units as its big brother) was ...

  7. Transmission line loudspeaker - Wikipedia

    en.wikipedia.org/wiki/Transmission_line_loudspeaker

    "It is difficult and costly to design and manufacture a time- and phase-accurate speaker system. Few of today’s high-end loudspeakers are time- and phase-accurate designs. The audio magazines need to appeal to a broad spectrum of advertisers including many who make speaker systems which are time incoherent.

  8. Loudspeaker - Wikipedia

    en.wikipedia.org/wiki/Loudspeaker

    A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]

  9. Electrodynamic speaker driver - Wikipedia

    en.wikipedia.org/wiki/Electrodynamic_speaker_driver

    All speaker drivers have a means of electrically inducing back-and-forth motion. Typically there is a tightly wound coil of insulated wire (known as a voice coil) attached to the neck of the driver's cone. In a ribbon speaker, the voice coil may be printed or bonded onto a sheet of very thin paper, aluminum, fiberglass or plastic.