Search results
Results from the WOW.Com Content Network
Bill Whitlock, president of Jensen Transformers, writes, "never, ever use devices such as 3 to 2-prong AC plug adapters, a.k.a. 'ground lifters', to solve a noise problem!" [ 5 ] Whitlock relates how an electrical fault in one device that is connected to its electricity source through an ungrounded cheater plug will result in dangerous, high ...
NEMA 1-15P (two-pole, no ground) and NEMA 5-15P (two-pole with ground pin) plugs are used on common domestic electrical equipment, and NEMA 5-15R is the standard 15-ampere electric receptacle (outlet) found in the United States, and under relevant national standards, in Canada (CSA C22.2 No. 42 [1]), Mexico (NMX-J-163-ANCE) and Japan (JIS C 8303).
This diagram was created with Inkscape, or with something else. This diagram uses embedded text that can be easily translated using a text editor. This version simplified from my table:NEMA receptacle pins.svg File:NEMA receptacle pins.svg by removing the bottom row's 3-phase power plugs and IEC computer connectors, as a way to simplify the table.
The pilot pin is located in the centre of main contact circle on 4- and 5-pin connectors. On 3-pin (2P+E) connectors, it is located on the contact circle opposite the ground pin. The other connectors are located 105° on either side of the earth pin, rather than 120° as in the smaller variants, to make room for the pilot pin.
Jack (least-movable connector of a connector pair), jack connector (connector may have "male" pin contacts and/or "female" socket contacts) all types of connectors, including pin headers. JP: Jumper (link) K: Relay or contactor: L: Inductor or coil or ferrite bead: LD, LED: LED: often changed to "D" for diode LS, SPK: Loudspeaker or buzzer: M ...
The plug and socket are rated 16 A 250 V AC and are intended for use only on systems having nominal voltages between 200 V and 250 V AC The plug pins are 4.5 mm in diameter, line and neutral are on centres 19 mm apart. The earth pin is offset by 3.0 mm. The line pin is on the right when looking at a socket with the earth pin offset up.
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
However a 10 A 5-pin plug cannot fit a 32 A 5-pin socket, as the plugs are in different groups and not only are their diameters different, but the position of the conductors also varies by a few degrees (for example the group 7/8 32 A plug has its L and N pins at 9 o'clock and 3 o'clock, while the group 1/2 20 A plug has its L and N pins at 10 ...