Search results
Results from the WOW.Com Content Network
Two king post trusses linked to support a roof. Key:1: ridge beam, 2: purlins, 3: common rafters. This is an example of a "double roof" with principal rafters and common rafters. A timber roof truss is a structural framework of timbers designed to bridge the space above a room and to provide support for a roof.
A knee wall is a short wall, typically under three feet (one metre) in height, used to support the rafters in timber roof construction. In his book A Visual Dictionary of Architecture, Francis D. K. Ching defines a knee wall as "a short wall supporting rafters at some intermediate position along their length."
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
The simplest form of roof framing is a common rafter roof. This roof framing has nothing but rafters and a tie beam at the bottoms of the rafters. The next step in the development of roof framing was to add a collar, called a collar beam roof. Collar beam roofs are suitable for spans up to around (4.5 meters). [5]
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
A symmetrical two-sided roof with two slopes on each side. Gargoyle A carved stone grotesque with a spout designed to convey water from a roof. Garret A habitable attic at the top of a larger building, generally with sloping walls, and with skylights or dormer windows. Gauged brickwork (also rubbed brickwork)
A view of a roof using common purlin framing. The purlins are marked in red. This view is from the inside of the building, below the roof. The rafters are the beams of wood angled upward from the ground. They meet at the top of the gable at a ridge beam, which has extra bracing to attach it to the rafters.
A simple rafter roof consists of rafters that the rafter foot rest on horizontal wall plates on top of each wall. [3] The top ends of the rafters often meet at a ridge beam, but may butt directly to another rafter to form a pair of rafters called a couple.