Search results
Results from the WOW.Com Content Network
An electric bicycle is a conventional bicycle that has been fitted with an electric motor. Most often electric bicycles or e-bikes are powered by rechargeable batteries however some experimental electric bicycles run directly on or recharge their batteries via solar panels, fuel cells, gas generators or other alternative energy sources. Using ...
Generally speaking, an electrical motor is far more efficient than an internal combustion engine at converting the stored potential energy into useful work; in an electric vehicle, traction motor efficiency can approach 90%, as there is minimal waste heat coming off the motor parts, and zero heat cast off by the coolant radiator and out of the ...
An engine–generator is the combination of an electrical generator and an engine (prime mover) mounted together to form a single piece of equipment. This combination is also called an engine–generator set or a gen-set. In many contexts, the engine is taken for granted and the combined unit is simply called a generator. An engine–generator ...
Large (land-based) electric powerplants built using this combined cycle can reach conversion efficiencies of over 60%. [1] If the turbines do not drive a propeller shaft directly and instead a turbo-electric transmission is used, the system is known as COGES (combined gas turbine-electric and steam).
An extension of the standard turboelectric propulsion scheme is COGES, or combined gas–electric and steam. In COGES a gas-turbine–electric primary transmission is used with a heat-recovery boiler in the exhaust flow to generate steam that drives a steam turbine that also generates electricity. Thus the system is thus even more efficient, as ...
A generator using permanent magnets (PMs) is sometimes called a magneto, or a permanent magnet synchronous generator (PMSG). Armature: The power-producing component of an electrical machine. In a generator, alternator, or dynamo, the armature windings generate the electric current, which provides power to an external circuit.
The motor–generator set may contain a large flywheel to improve its ride-through; however, consideration must be taken in this application as the motor–generator will lose speed and may draw a large current when power returns or the circuit-breaker is re-closed. If the speed loss is excessive (the power outage is too long), the re-closure ...
A specific model of a generator operated as a standby generator may only need to operate for a few hours per year, but the same model operated as a prime power generator must operate continuously. When running, the standby generator may be operated with a specified - e.g. 10% overload that can be tolerated for the expected short running time.