Ads
related to: testing a ballast with multimeter tester
Search results
Results from the WOW.Com Content Network
Oil discharge monitoring equipment (ODME) is based on a measurement of oil content in the ballast and slop water, to measure conformance with regulations. [1] The apparatus is equipped with a GPS, data recording functionality, an oil content meter and a flow meter. [2]
A test light, test lamp, voltage tester, or mains tester is a piece of electronic test equipment used to determine the presence of electricity in a piece of equipment under test. A test light is simpler and less costly than a measuring instrument such as a multimeter , and often suffices for checking for the presence of voltage on a conductor.
Multimeter e.g., VOM (Volt-Ohm-Milliammeter) or DMM (Digital Multimeter) (Measures all of the above) LCR meter - inductance (L), capacitance (C) and resistance (R) meter (measure LCR values) The following are used for stimulus of the circuit under test: Power supplies; Signal generator; Digital pattern generator; Pulse generator
Multimeter test leads. A multimeter can use many different test probes to connect to the circuit or device under test. Crocodile clips, retractable hook clips, and pointed probes are the three most common types. Tweezer probes are used for closely spaced test points, as for instance surface-mount devices. The connectors are attached to flexible ...
Reference ballast operates the lamp at its ANSI specified nominal power rating. [9] [10] The ballast factor of practical ballasts must be considered in lighting design; a low ballast factor may save energy, but will produce less light and short the lamp life. With fluorescent lamps, ballast factor can vary from the reference value of 1.0.
A dummy load is a device used to simulate an electrical load, usually for testing purposes.In radio a dummy antenna is connected to the output of a radio transmitter and electrically simulates an antenna, to allow the transmitter to be adjusted and tested without radiating radio waves.
To do this test, you need to have an insulation resistance tester, which may be a small hand held battery powered device, up to a larger luggage sized tool able to achieve higher test voltages. Variables to choose before starting an electrical resistance test is the test voltage, test duration, and test points.
A "Sylvania Electric" multimeter tester for vacuum tubes. A tube tester is an electronic instrument designed to test certain characteristics of vacuum tubes (thermionic valves). Tube testers evolved along with the vacuum tube to satisfy the demands of the time, and their evolution ended with the tube era.
Ads
related to: testing a ballast with multimeter tester