Search results
Results from the WOW.Com Content Network
The DHCP server permanently assigns an IP address to a requesting client from a range defined by an administrator. This is like dynamic allocation, but the DHCP server keeps a table of past IP address assignments, so that it can preferentially assign to a client the same IP address that the client previously had. Manual allocation
DHCPv6 can provide this information whether it is being used to assign IP addresses or not. DHCPv6 can provide host with the addresses of Domain Name System (DNS) servers, but they can also be provided through Neighbor Discovery Protocol, which is the mechanism for stateless autoconfiguration. [1]
The DHCP server then offers the "lease" of an IP address to the client, which the client is free to request or ignore. If the client requests it and the server acknowledges it, then the client is permitted to use that IP address for the "lease time" specified by the server. At some point before the lease expires, the client must re-request the ...
For instance, if a printer is moved from one floor to another it might be assigned a new IP address by the local DHCP server. [4] To address the need for automatic configuration, Microsoft implemented NetBIOS Name Service, part of which is the Computer Browser Service already in Microsoft Windows for Workgroups 3.11 [5] as early as 1992
Used for loopback addresses to the local host [1] 169.254.0.0/16 169.254.0.0–169.254.255.255 65 536: Subnet Used for link-local addresses [5] between two hosts on a single link when no IP address is otherwise specified, such as would have normally been retrieved from a DHCP server 172.16.0.0/12 172.16.0.0–172.31.255.255 1 048 576: Private ...
If a DHCP client outside the DHCP server's subnet broadcasts an address request, it is the helper that forwards the message to the DHCP server. The server then chooses an address and sends the client a unicast message, using the helper to send the message back to the client's subnet. The address is reserved for a limited time while the DHCP ...
A network administrator may configure DHCP by allocating specific IP addresses based on MAC address. DHCP is not the only technology used to assign IP addresses dynamically. Bootstrap Protocol is a similar protocol and predecessor to DHCP. Dialup and some broadband networks use dynamic address features of the Point-to-Point Protocol.
Similar to a unicast address, the prefix of an IPv6 multicast address specifies its scope, however, the set of possible scopes for a multicast address is different. The 4-bit scope field (bits 12 to 15) is used to indicate where the address is valid and unique.