Search results
Results from the WOW.Com Content Network
The characteristic impedance of an infinite transmission line at a given angular frequency is the ratio of the voltage and current of a pure sinusoidal wave of the same frequency travelling along the line. This relation is also the case for finite transmission lines until the wave reaches the end of the line. Generally, a wave is reflected back ...
Voltage standing wave ratio (VSWR) (pronounced "vizwar" [ 1][ 2]) is the ratio of maximum to minimum voltage on a transmission line . For example, a VSWR of 1.2 means a peak voltage 1.2 times the minimum voltage along that line, if the line is at least one half wavelength long. A SWR can be also defined as the ratio of the maximum amplitude to ...
An RF connector ( radio frequency connector) is an electrical connector designed to work at radio frequencies in the multi-megahertz range. RF connectors are typically used with coaxial cables and are designed to maintain the shielding that the coaxial design offers. Better models also minimize the change in transmission line impedance at the ...
The nominal value of the input, output or image impedance of a port of a network, especially a network intended for use with a transmission line, such as filters, equalisers and amplifiers. The nominal value of the input impedance of a radio frequency antenna. The actual impedance may vary quite considerably from the nominal figure with changes ...
The telegrapher's equations (or just telegraph equations) are a set of two coupled, linear equations that predict the voltage and current distributions on a linear electrical transmission line. The equations are important because they allow transmission lines to be analyzed using circuit theory. [ 1] The equations and their solutions are ...
The current revision includes Category 5e (100 MHz), 6 (250 MHz), 6A (500 MHz), and 8 (2,000 MHz). Categories 7 and 7A were not officially recognized by TIA and were generally only used outside the United States. Category 8 was published with ANSI/TIA‑568‑C.2‑1 (June 2016) [9] to meet the performance specification intended by Category 7.
Return loss is a measure of how well devices or lines are matched. A match is good if the return loss is high. A high return loss is desirable and results in a lower insertion loss . From a certain perspective 'Return Loss' is a misnomer. The usual function of a transmission line is to convey power from a source to a load with minimal loss.
SMA connectors are rated for up to 500 mating cycles, [8] but to achieve this it is necessary to properly torque the connector when making the connection. A 5 ⁄ 16 inch torque wrench is required for this, set to 3–5 in·lbf (0.3 to 0.6 N·m) for brass, and 7–10 in·lbf (0.8 to 1.1 N·m) for stainless steel connectors. Flats are sometimes ...