Search results
Results from the WOW.Com Content Network
The lever is let off for down wind sailing, so the main sail becomes full. Alternatively the outhaul tail can be attached to a block and tackle system so that it can be adjusted to many positions. [1] Jib Fairleads, which determine the sheeting angle, depth of the sail, height of the clew, leach tension and other sail trim variables. [5]
A raffee sail is a triangular topsail carried aboard certain sailing ships. Originally used in ancient Rome to maneuver ships at sea, [1] the raffee was eventually implemented as a downwind sail set below a square-rigged yard to fill in areas needed for light airs. In later pilot schooners, it was a triangular sail set above a yard from the ...
There, in the former Value City warehouse and Schottenstein's store, more than 120 workers are building "Connect Housing Blocks," 14-foot-wide housing units that can be combined to form apartment ...
Square rig is a generic type of sail and rigging arrangement in which the primary driving sails are carried on horizontal spars which are perpendicular, or square, to the keel of the vessel and to the masts. These spars are called yards and their tips, outside the lifts, are called the yardarms. [1] A ship mainly rigged so is called a square ...
Code 1 is a light air reaching sail, where the apparent wind angles at low speeds has a significant effect to create angles of less than 90 degrees. Code 2 is a medium air running sail, used for apparent wind angles over 90 degrees. Code 3 is a medium air reaching sail, used for apparent wind angles near 90 degrees.
Clewlines and buntlines are lines used to handle the sails of a square rigged ship. The leechlines are clearly visible running inwards and upwards from the edges of the sail. The buntlines up the front of the sail can be seen too, but their run to the blocks on the shrouds is obscured because the sail is set on a lifting yard.
Sails are classified as "triangular sails", "quadrilateral fore-and-aft sails" (gaff-rigged, etc.), and "square sails". [38] The top of a triangular sail, the head , is raised by a halyard , The forward lower corner of the sail, the tack , is shackled to a fixed point on the boat in a manner to allow pivoting about that point—either on a mast ...
49er with a gennaker (yellow). A gennaker is a sail that was developed around 1990. Used when sailing downwind, it is a cross between a genoa and a spinnaker.It is not symmetric like a true spinnaker but is asymmetric like a genoa, but the gennaker is not attached to the forestay like a jib or genoa.