Search results
Results from the WOW.Com Content Network
[citation needed] High-power in-car audio systems using 2-ohm speaker circuits require thicker wire than 4 to 8-ohm home audio applications. Most consumer applications use two conductor wire. A common rule of thumb is that the resistance of the speaker wire should not exceed 5 percent of the rated impedance of the system.
The magnetic immunity of star quad cable is a function of the accuracy of the star-quad geometry, the accuracy of the impedance balancing, and the common-mode rejection ratio of the balanced receiver. [2] Star-quad cable typically provides a 10 dB to 30 dB reduction [3] in magnetically-induced interference. [4] [5] [6]
An automotive wiring diagram, showing useful information such as crimp connection locations and wire colors. These details may not be so easily found on a more schematic drawing. A wiring diagram is a simplified conventional pictorial representation of an electrical circuit. It shows the components of the circuit as simplified shapes, and the ...
A loudspeaker (commonly referred to as a speaker or, more fully, a speaker system) is a combination of one or more speaker drivers, an enclosure, and electrical connections (possibly including a crossover network). The speaker driver is an electroacoustic transducer [1]: 597 that converts an electrical audio signal into a corresponding sound. [2]
Wire crossover symbols for circuit diagrams. The CAD symbol for insulated crossing wires is the same as the older, non-CAD symbol for non-insulated crossing wires. To avoid confusion, the wire "jump" (semi-circle) symbol for insulated wires in non-CAD schematics is recommended (as opposed to using the CAD-style symbol for no connection), so as to avoid confusion with the original, older style ...
From about 1900 to the 1950s, the "lowest frequency in practical use" in recordings, broadcasting and music playback was 100 Hz. [9] When sound was developed for motion pictures, the basic RCA sound system was a single 8-inch (20 cm) speaker mounted in straight horn, an approach which was deemed unsatisfactory by Hollywood decisionmakers, who hired Western Electric engineers to develop a ...
The 1 / 2 λ dipole and the 1 / 2 λ folded dipole are commonly taken as having nominal impedances of 75 Ω and 300 Ω, respectively. [13] An installed antenna's feed-point impedance varies above and below the quoted value, depending on its installation height above the ground and the electrical properties of the surrounding earth.
Car audio amplifiers commonly have only a notional 13.8 volt supply, which would ordinarily limit the voltage swing available at the output to + and − 6.9 volts. Whilst it would be possible to achieve higher voltage swings by such means as DC-to-DC conversion of the supply voltage, using a bridge mode design allows for twice the voltage swing ...