enow.com Web Search

  1. Ads

    related to: industrial gas burner parts

Search results

  1. Results from the WOW.Com Content Network
  2. Gas burner - Wikipedia

    en.wikipedia.org/wiki/Gas_burner

    Propane burner with a Bunsen flame Oxy-Acetylene for cutting through steel rails Flame of a gas and oil, in a dual burner. A gas burner is a device that produces a non-controlled flame by mixing a fuel gas such as acetylene, natural gas, or propane with an oxidizer such as the ambient air or supplied oxygen, and allowing for ignition and ...

  3. Industrial furnace - Wikipedia

    en.wikipedia.org/wiki/Industrial_furnace

    An industrial furnace, also known as a direct heater or a direct fired heater, is a device used to provide heat for an industrial process, typically higher than 400 degrees Celsius. [1] They are used to provide heat for a process or can serve as reactor which provides heats of reaction.

  4. Single-ended recuperative burner - Wikipedia

    en.wikipedia.org/wiki/Single-ended_recuperative...

    A single-ended recuperative (SER) burner is a type of gas burner used in high-temperature industrial kilns and furnaces. These burners are used where indirect heating is required, e.g. where the products of combustion are not allowed to combine with the atmosphere of the furnace. The typical design is a tubular (pipe) shape with convoluted ...

  5. Combustor - Wikipedia

    en.wikipedia.org/wiki/Combustor

    A combustor is a component or area of a gas turbine, ramjet, or scramjet engine where combustion takes place. It is also known as a burner, burner can, combustion chamber or flame holder. In a gas turbine engine, the combustor or combustion chamber is fed high-pressure air by the compression system. The combustor then heats this air at constant ...

  6. LO-NOx burner - Wikipedia

    en.wikipedia.org/wiki/LO-NOx_burner

    It is well established that conventional "blue flame" or bunsen gas burners produce oxides of nitrogen at levels of 30-50 nanograms per joule [5] [6] and are as such not considered to have potential for NO x reduction. Surface combustion burners or radiant tile burners in comparison produce nitrogen oxides' levels 60-70% less. [6]

  7. Pulverized coal-fired boiler - Wikipedia

    en.wikipedia.org/wiki/Pulverized_coal-fired_boiler

    The powdered coal from the pulverizer is directly blown to a burner in the boiler. The burner mixes the powdered coal in the air suspension with additional pre-heated combustion air and forces it out of a nozzle similar in action to fuel being atomized by a fuel injector in an internal combustion engine. Under operating conditions, there is ...

  8. Cyclone furnace - Wikipedia

    en.wikipedia.org/wiki/Cyclone_furnace

    Crushed coal and a small amount of primary air enter from the front of the cyclone into the burner. In the main cyclone burner, secondary air is introduced tangentially, causing a circulating gas flow pattern. The products, flue gas and un-combusted fuel, then leave the burner and pass over the boiler tubes.

  9. Inspirator - Wikipedia

    en.wikipedia.org/wiki/Inspirator

    The Venturi CSA is optimally 43% of the Burner CSA, and positions and lengths of tubes are described in the document. The "optimum" expansion beyond the venturi is at 2 degrees taper (4 degrees included angle). This design of "Inspirator" can be seen in many domestic and industrial gas burners in use today.

  1. Ads

    related to: industrial gas burner parts