Search results
Results from the WOW.Com Content Network
The .40 S&W (10.2×22mm) is a rimless pistol cartridge developed jointly by American firearms manufacturers Smith & Wesson and Winchester in 1990. [3] The .40 S&W was developed as a law enforcement cartridge designed to duplicate performance of the Federal Bureau of Investigation's (FBI) reduced-velocity 10mm Auto cartridge which could be retrofitted into medium-frame (9 mm size) semi ...
The .45 ACP, when loaded up to maximum standard pressures (none of these loads were listed as +P) will outperform .40 S&W in most weights. A quick look at the .45 GAP (which is loaded to .45 ACP +P pressures) shows that the 185 grain bullet is pushed to 1090 fps, for 488 ft. lbs. of muzzle energy; .45 ACP +P should be equal to or (since it can use a slightly slower, less dense powder) slightly ...
Redding Reloading, according to their catalog, offers custom made 3-die sets for the .400 Corbon. [23] Lubricating of the bottleneck case can be avoided when starting with .400 Corbon cases by using a carbide .45 ACP sizing die before using the .400 Corbon sizing die. Using a five-stage progressive reloading press makes this less of a chore.
The .41 AE can be ballistically similar to the .40 S&W, to the point that many reloading manuals suggest using .40 S&W load data in the .41 AE.Original IMI factory cartridges are much higher powered, approaching 10mm levels, pushing a 170 gr (11.02 g) bullet at 1215 ft/s.
Although not originally designed for handguns, several rifle and shotgun cartridges have also been chambered in a number of large handguns, primarily in revolvers like the Phelps Heritage revolver, Century Arms revolver, Thompson/Centre Contender break-open pistol, Magnum Research BFR, and the Pfeifer Zeliska revolvers.
The case is necked out and trimmed off above the shoulder at a case-length of 1.700", with a COAL of 2.250", resulting in a "straight-wall" cartridge. It uses .4005" jacketed rifle bullets, and can accept bullets from .40 S&W and 10mm Auto pistols (135gr–230gr). 400 Legend, Proprietary. The rebated rim dimensions exactly match the 6.8mm ...
The Smith & Wesson Model 40 originally debuted as the Centennial in 1952 and was renamed the Model 40 in 1957. The Model 40 is chambered in .38 special and has a five-round capacity. It is a snub-nose revolver with a 1 7/8-inch barrel. It is built on Smith & Wesson's J-frame and weighs 21 oz. empty. [2]
The cartridge was made by necking down and slightly stretching the .40 S&W case, which itself derived from the 10mm Auto..400 Corbon. This cartridge was designed to produce 10mm Auto ballistics in a cartridge that could be chambered in a .45 ACP pistol with a simple barrel swap. It was made by necking a .45 ACP down to .40 (10 mm).