Search results
Results from the WOW.Com Content Network
It is defined as the pressure exerted by a column of water of 1 inch in height at defined conditions. At a temperature of 4 °C (39.2 °F) pure water has its highest density (1000 kg/m 3 ). At that temperature and assuming the standard acceleration of gravity , 1 inAq is approximately 249.082 pascals (0.0361263 psi ).
Until 1982, STP was defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of 101.325 kPa (1 atm). Since 1982, STP is defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of 100 kPa (1 bar). Conversions between each volume flow metric are calculated using the following formulas: Prior to 1982,
Since 1982, STP has been defined as a temperature of 273.15 K (0 °C, 32 °F) and an absolute pressure of exactly 1 bar (100 kPa, 10 5 Pa). NIST uses a temperature of 20 °C (293.15 K, 68 °F) and an absolute pressure of 1 atm (14.696 psi, 101.325 kPa). [3] This standard is also called normal temperature and pressure (abbreviated as NTP).
The chart below [6] lists the sizes of various wine bottles in multiples relating to a standard bottle of wine, which is 0.75 litres (0.20 US gal; 0.16 imp gal) (six 125 mL servings). The "wineglassful"—an official unit of the apothecaries' system of weights —is much smaller at 2.5 imp fl oz (71 mL ).
The table of imperial avoirdupois mass is the same as the United States table up to one pound, but above that point, the tables differ. The imperial system has a hundredweight, defined as eight stone of 14 lb each, or 112 lb ( 50.802 345 44 kg ), whereas a US hundredweight is 100 lb ( 45.359 237 kg ).
A hogshead was also used as unit of measurement for sugar in Louisiana for most of the 19th century. Plantations were listed in sugar schedules by the number of hogsheads of sugar or molasses produced. Used for sugar in the 18th and 19th centuries in the British West Indies, a hogshead weighed on average 16 cwt / 813kg.
Dry measures are units of volume to measure bulk commodities that are not fluids and that were typically shipped and sold in standardized containers such as barrels.They have largely been replaced by the units used for measuring volumes in the metric system and liquid volumes in the imperial system but are still used for some commodities in the US customary system.
where T, temperature of the moist air, is given in units of kelvin, and p is given in units of millibars (hectopascals). The formula is valid from about −50 to 102 °C; however there are a very limited number of measurements of the vapor pressure of water over supercooled liquid water. There are a number of other formulae which can be used. [14]