enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Polyethylene - Wikipedia

    en.wikipedia.org/wiki/Polyethylene

    Polyethylene absorbs almost no water; the gas and water vapour permeability (only polar gases) is lower than for most plastics. Oxygen, carbon dioxide and flavorings, on the other hand, can pass it easily. Polyethylene burns slowly with a blue flame having a yellow tip and gives off an odour of paraffin (similar to candle flame). The material ...

  3. High-density polyethylene - Wikipedia

    en.wikipedia.org/wiki/High-density_polyethylene

    HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]

  4. Ethylene - Wikipedia

    en.wikipedia.org/wiki/Ethylene

    Polyethylene, also called polyethene and polythene, is the world's most widely used plastic. It is primarily used to make films in packaging , carrier bags and trash liners . Linear alpha-olefins , produced by oligomerization (formation of short-chain molecules) are used as precursors , detergents , plasticisers , synthetic lubricants ...

  5. Polymer - Wikipedia

    en.wikipedia.org/wiki/Polymer

    The degradation of polyethylene occurs by random scission—a random breakage of the bonds that hold the atoms of the polymer together. When heated above 450 °C, polyethylene degrades to form a mixture of hydrocarbons. In the case of chain-end scission, monomers are released and this process is referred to as unzipping or depolymerization ...

  6. Plastic extrusion - Wikipedia

    en.wikipedia.org/wiki/Plastic_extrusion

    A common post-extrusion process for plastic sheet stock is thermoforming, where the sheet is heated until soft (plastic), and formed via a mold into a new shape. When vacuum is used, this is often described as vacuum forming. Orientation (i.e. ability/ available density of the sheet to be drawn to the mold which can vary in depths from 1 to 36 ...

  7. Low-density polyethylene - Wikipedia

    en.wikipedia.org/wiki/Low-density_polyethylene

    Low-density polyethylene (LDPE) is a thermoplastic made from the monomer ethylene. It was the first grade of polyethylene, produced in 1933 by John C. Swallow and M.W Perrin who were working for Imperial Chemical Industries (ICI) using a high pressure process via free radical polymerization. [1] Its manufacture employs the same method today.

  8. Ultra-high-molecular-weight polyethylene - Wikipedia

    en.wikipedia.org/wiki/Ultra-high-molecular...

    The Properties of Polyethylene Crystallized Under the Orientation and Pressure Effects of a Pressure Capillary Viscometer, Journal of Applied Polymer Science vol. 14, pp. 2305–2317 (1970). Kanamoto, On Ultra-High Tensile by Drawing Single Crystal Mats of High Molecular Weight Polyethylene, Polymer Journal vol. 15, No. 4, pp. 327–329 (1983).

  9. Vacuum forming - Wikipedia

    en.wikipedia.org/wiki/Vacuum_forming

    A simple visualization of the forming process Vacuum forming machine to produce inner liner/food liner of refrigerator. Vacuum forming is a simplified version of thermoforming, where a sheet of plastic in various forms of High Impact Polystyrene Sheet (HIPS) for low impact products, or ABS for bathroom shower trays, and HDPE for exterior vehicle parts, plus various other types of vacuum ...