enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Patch cable - Wikipedia

   en.wikipedia.org/wiki/Patch_cable

   A patch cable, patch cord or patch lead is an electrical or fiber-optic cable used to connect ("patch in") one electronic or optical device to another for signal routing. Devices of different types (e.g., a switch connected to a computer, or a switch to a router ) are connected with patch cords.

3. Ethernet crossover cable - Wikipedia

   en.wikipedia.org/wiki/Ethernet_crossover_cable

   An Ethernet crossover cable is a crossover cable for Ethernet used to connect computing devices together directly. It is most often used to connect two devices of the same type, e.g. two computers (via their network interface controllers ) or two switches to each other.

4. Networking cable - Wikipedia

   en.wikipedia.org/wiki/Networking_cable

   A patch cable is an electrical or optical cable used to connect one electronic or optical device to another for signal routing. Devices of different types (e.g. a switch connected to a computer, or a switch connected to a router) are connected with patch cables.

5. Medium-dependent interface - Wikipedia

   en.wikipedia.org/wiki/Medium-dependent_interface

   These are referred to as MDI and MDI-X (medium-dependent interface crossover). When connecting an MDI port to an MDI-X port, a straight-through cable is used, while to connect two MDI ports or two MDI-X ports, a crossover cable must be used. Conventionally, MDI is used on end devices and routers while MDI-X is used on hubs and switches.

6. List of interface bit rates - Wikipedia

   en.wikipedia.org/wiki/List_of_interface_bit_rates

   Many device interfaces or protocols (e.g., SATA, USB, SAS, PCIe) are used both inside many-device boxes, such as a PC, and one-device-boxes, such as a hard drive enclosure. Accordingly, this page lists both the internal ribbon and external communications cable standards together in one sortable table.

7. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...