Search results
Results from the WOW.Com Content Network
An animated simulation of an axial compressor. The static blades are the stators.. An axial compressor is a gas compressor that can continuously pressurize gases.It is a rotating, airfoil-based compressor in which the gas or working fluid principally flows parallel to the axis of rotation, or axially.
A compressor map is a chart which shows the performance of a turbomachinery compressor.This type of compressor is used in gas turbine engines, for supercharging reciprocating engines and for industrial processes, where it is known as a dynamic compressor.
V f = flow velocity (axial component in case of axial machines, radial component in case of radial machines). The following angles are encountered during the analysis: α = absolute angle is an angle made by V with the plane of the machine (usually the nozzle angle or the guide blade angle) i.e. angle made by absolute velocity V and the ...
The velocity triangle [2] (Figure 2.) for the flow process within the stage represents the change in fluid velocity as it flows first in the stator or the fixed blades and then through the rotor or the moving blades. Due to the change in velocities there is a corresponding pressure change. Figure 2. Velocity Triangle for fluid flow in turbine
Stalling is the separation of flow from the compressor blade surface as shown in the Figure 6. At low flow rates the angle of attack increases over the critical or maximum angle that the aerodynamic profile can sustain, and due to this there occurs the flow separation on the suction side of the blades which is known as positive stalling. If the ...
There is also a third category, called mixed flow machines, where both radial and axial flow velocity components are present. [ 2 ] Turbomachines may be further classified into two additional categories: those that absorb energy to increase the fluid pressure , i.e. pumps , fans , and compressors , and those that produce energy such as turbines ...
In the axial compressor the air flows parallel to the axis of rotation. Axial compressors are made to be multi-staged. A stage consists of a row of rotating blades called the rotor, which are connected to the central shaft and a row of stationary or fixed blades called stator. In axial flow compressor, the air flows from stage to stage.
The term describes violent air flow oscillating in the axial direction of a compressor, which indicates the axial component of fluid velocity varies periodically and may even become negative. In early literature, the phenomenon of compressor surge was identified by audible thumping and honking at frequencies as low as 1 Hertz, pressure ...