Ad
related to: how to extend rafters length- Tap To Get Started
Don't Slow Down To
Find Roofing Experts
- Clean Your Roof
Hire a professional to clean your
roof. Enter your zip to get started
- Get Matched With A Roofer
Local Background Checked Pros
Fast and Free Quotes
- Roofing Repairs
Find Local Professionals
For All Type of Roof Repairs
- Tap To Get Started
Search results
Results from the WOW.Com Content Network
For barns up to 30 feet (9.1 m) wide, rafters were commonly made from four pieces of 1x3 (actually 3/4 inches thick) random length boards with end joints of at least two feet apart nailed together and also bolted every three feet. Larger barns required stronger rafters, such as five pieces of 1x4. [5]
A knee wall is a short wall, typically under three feet (one metre) in height, used to support the rafters in timber roof construction. In his book A Visual Dictionary of Architecture, Francis D. K. Ching defines a knee wall as "a short wall supporting rafters at some intermediate position along their length."
Compass rafter: A rafter curved or bowed on the top (the top surface of a rafter is called its "back") or both the top and bottom surfaces. Curb rafter: The upper rafters in a curb (kerb, gambrel, Mansard roof) roof. Hip rafter (angle rafter): The rafter in the corners of a hip roof. The foot of a hip rafter lands on a dragon beam.
Light frame material dimensions range from 38 by 89 mm (1.5 by 3.5 in); i.e., a Dimensional number two-by-four to 5 cm by 30 cm (two-by-twelve inches) at the cross-section, and lengths ranging from 2.5 metres (8.2 ft) for walls to 7 metres (23 ft) or more for joists and rafters.
A hammer-beam is a form of timber roof truss, allowing a hammerbeam roof to span greater than the length of any individual piece of timber.In place of a normal tie beam spanning the entire width of the roof, short beams – the hammer beams – are supported by curved braces from the wall, and hammer posts or arch-braces are built on top to support the rafters and typically a collar beam.
By supporting the rafters they allow longer spans than the rafters alone could span, thus allowing a wider building. Purlin plates are very commonly found in large old barns in North America. A crown plate has similarities to a purlin plate but supports collar beams in the middle of a timber-framed building.
Freezing is a great way to extend the shelf life of baked goods. By tightly wrapping baked goods in plastic wrap or aluminum foil, followed by an air-tight container or freezer bag, you can ...
Historically, roof pitch was designated in two other ways: A ratio of the ridge height to the width of the building (span) [6] and as a ratio of the rafter length to the width of the building. [7] Commonly used roof pitches were given names such as: Greek: the ridge height is 1 ⁄ 9 to 1 ⁄ 7 the span (an angle of 12.5° to 16°);
Ad
related to: how to extend rafters length